Loading ...
Loading ...
Loading ...
22
IV. Preparing the Appliance for Periods of Non-Use
During extended periods of non-use, extended absences, or in sub-freezing
temperatures, follow the instructions below. When the appliance is not used for two or
three days under normal conditions, it is sufficient to move the power switch to the "OFF"
position.
WARNING
Only qualied service technicians should service the appliance.
NOTICE
During extended periods of non-use, extended absences, or in sub-freezing
temperatures, follow the instructions below to reduce the risk of costly water
damage.
1) Close the water supply line shut-off valve and open the water supply line drain valve.
2) Dispense all of the ice from the storage bin.
3) Move the power switch to the "OFF" position, then remove the louver and air lter. See
Fig. 6. Move the control switch to the "DRAIN" position, then move the power switch to
the "ON" position. Allow the water system to drain completely (you will see the water
draining into the drain pan).
Note: a) When the appliance has power, a momentary pause in the "OFF" position is
necessary to de-energize the control board when moving the control switch
between "ICE" and "DRAIN." Otherwise there is a delay of several minutes
before the new selection takes effect.
b) If the control switch is left in the "DRAIN" position for 10 minutes or more, a
2-beep alarm sounds every 5 seconds. Move the control switch out of the
"DRAIN" position to clear the alarm.
4) Attach a compressed air or carbon dioxide supply to the water supply line drain valve.
5) While engaging the water dispense switch, blow out the water dispense valve using the
compressed air or carbon dioxide supply. After blowing out the water dispense valve,
leave the compressed air or carbon dioxide supply owing. Move the control switch
to the "ICE" position to open the inlet water valve and briey blow out the valve. After
blowing out the inlet water valve, move the power switch to the "OFF" position.
6) Close the water supply line drain valve.
7) Unplug the appliance from the electrical outlet.
8) Remove the front panel. On the push-button model, disconnect the connector. Remove
the top panel and bin top. Clean the storage bin liner and the inside of the bin top
using a neutral cleaner. Rinse thoroughly after cleaning. NOTICE! Be sure to keep the
switch mounted on the bin top dry. Dry the storage bin liner and the inside of the bin
top using a clean cloth.
9) Replace the air lter, louver, bin top, and panels in their correct positions. On the
push-button model, reconnect the connector. WARNING! CHOKING HAZARD: Ensure
all components, fasteners, and thumbscrews are securely in place. Make sure
that none have fallen into the storage bin.
Loading ...
Loading ...