Loading ...
Loading ...
Loading ...
10
Fig. 1
B. Checks Before Installation
• Visually inspect the exterior of the shipping container and immediately report any
damage to the carrier. Upon opening the container, any concealed damage should also
be immediately reported to the carrier.
• Remove the shipping carton, tape, and packing material. If any are left in the appliance,
it will not work properly.
• See the nameplate on the rear panel, and check that your voltage supplied corresponds
with the voltage specied on the nameplate.
• Remove the panels to prevent damage when installing the appliance. See "II.C. How to
Remove Panels."
• Remove the package containing the accessories.
• Remove the protective plastic lm from the panels. If the appliance is exposed to the
sun or to heat, remove the lm after the appliance cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade turns freely.
• The appliance can be installed on a countertop or on an optional stand. If using an
optional stand, Hoshizaki Stand SD-270 is recommended.
C. How to Remove Panels
See Fig. 1 or Fig. 2
• Front Panel: Remove the screw. Lift up and towards you. On the push-button model,
disconnect the connector.
• Top Panel: Lift up at front slightly, push rearward and lift off.
• Apron Panel: Remove the grille. Remove the screws and pull towards you. On the
Opti-Serve model, disconnect the connectors.
• Rear Panel: Remove the screws and pull towards you.
• Side Panel: Remove the screws and pull towards you.
Top Panel
Front Panel
Apron Panel
Side
Panel
Grille
Connector
Rear
Panel
Side
Panel
Top Panel
Front Panel
Apron Panel
Side
Panel
Grille
Connectors
Rear
Panel
Side
Panel
DCM-270BAH
(push-button model)
DCM-270BAH-OS
(Opti-Serve model)
Fig. 2
Loading ...
Loading ...
Loading ...