Hoshizaki DCM270BAH User Manual

Loading ...

D. Setup

1) Position the appliance in the selected permanent location. If attaching to a stand, refer

to the installation instructions included with the stand.

2) Level the appliance from side-to-side and front-to-rear by adjusting the legs.

3) Replace the panels in their correct positions.

E. Electrical Connection

WARNING

• Electrical connection must meet national, state, and local electrical code

requirements. Failure to meet these code requirements could result in death,

electric shock, serious injury, re, or damage.

• The appliance requires an independent power supply of proper capacity. See

the nameplate for electrical specications. Failure to use an independent power

supply of proper capacity can result in a tripped breaker, blown fuse, damage to

existing wiring, or component failure. This could lead to heat generation or re.

• THE APPLIANCE MUST BE GROUNDED: The appliance is equipped with a

NEMA5-15 three-prong grounding plug to reduce the risk of potential shock

hazards. It must be plugged into a properly grounded, independent 3-prong wall

outlet. If the outlet is a 2-prong outlet, it is your personal responsibility to have

a qualied electrician replace it with a properly grounded, independent 3-prong

wall outlet. Do not remove the ground prong from the power cord and do not use

an adapter plug. Failure to properly ground the appliance could result in death or

serious injury.

• Do not use an extension cord.

• To reduce the risk of electric shock, do not touch the power switch, control switch,

or plug with damp hands. Make sure the power switch is in the "OFF" position

before plugging in or unplugging the appliance.

• Do not use an appliance with a damaged power cord. The power cord should not

be altered, jerked, bundled, weighed down, pinched, or tangled. Such actions

could result in electric shock or re. To unplug the appliance, be sure to pull the

plug, not the cord, and do not jerk the cord.

• The GREEN ground wire in the factory-installed power cord is connected to the

appliance. If it becomes necessary to remove or replace the power cord, be sure

to connect the power cord's ground wire to this screw upon reattachment.

• Usually an electrical permit and services of a licensed electrician are required.

• The maximum allowable voltage variation is ±10 percent of the nameplate rating.

Loading ...

Hoshizaki DCM270BAH Coffe Maker