Loading ...
Loading ...
Loading ...
30
Adjusting the Speed Sensor
If the calibration does not pass you may need to check the speed sensor alignment.
1. Remove the motor cover hood by loosening the 4 screws that hold it in place (you do not need to remove them
completely).
2. The speed sensor is located on the left side of the frame, right next to the front roller pulley (the pulley will have a belt
around it that also goes to the motor). The speed sensor is small and black with a wire connected to it.
3. Make sure the sensor is as close as possible to the pulley without touching it. You will see a magnet on the face of the
pulley; make sure the sensor is aligned with the magnet. There is a screw that holds the sensor in place that needs to be
loosened to adjust the sensor. Re-tighten the screw when nished.
Engineering Mode Menu
The console has built in maintenance/diagnostic software. The software will allow you to change the console settings from
English to Metric and turn off the beeping of the speaker when a key is pressed for example. To enter the Engineering
Mode Menu, press and hold down the Start, Stop and Enter keys. Keep holding the keys down for about 5 seconds and
the Message Center will display Engineering Mode Menu. Press the Enter key to access the menu below:
1. Key Test (Will allow you to test all the keys to make sure they are functioning)
2. Display Test (Tests all the display functions)
3. Functions (Press Enter to access settings; use the Speed Up and Down keys to scroll)
I. Display Mode (Turn off to have the console power down automatically after 30 minutes of inactivity)
II. Pause Mode (Turn on to allow 5 minutes of pause, turn off to have the console pause indenitely)
III. Maintenance (Reset lube message and odometer readings)
IV. Units (Sets the display to readout in English or Metric display measurements)
V. Key Tone (Turns off the speaker so no beeping sound is heard)
4. Security (Allows you to lock the keypad so no unauthorized use of the machine is allowed. When the child lock is
enabled, the console will not allow the keypad to operate unless you press and hold the Start and Enter buttons for 3
seconds to unlock the console.)
5. Exit
Loading ...
Loading ...
Loading ...