Loading ...
Loading ...
Loading ...
29
1. Turn the power switch off and unplug the power cord from the wall outlet
2. Measure 18” from the edge of the motor cover; kneel down and reach under the belt approximately 4- 6” from one
edge. Squirt a line of lubricant about 1/8” wide x 15” long in an “S” pattern perpendicular to the motor cover.
3. Repeat the process on the opposite side.
4. Plug the electrical cord back into the outlet and turn the power switch on.
5. Walk on the belt at a moderate speed for ve minutes to evenly distribute the silicone lube.
Note: If the “Lube” message appears on the console, perform the following procedure to reset the message:
• To enter the Engineering Mode Menu press and hold down the Start, Stop and Enter keys, then at the same time insert the
safety key. Keep holding the keys down until the Message Center displays Engineering Mode Menu. Press the Enter button
to access
• Press the Speed + button (or Speed – button to go backwards) until “Functions” appears; press Enter
• Press the Speed + button until “Maintenance” message appears; press Enter
• Press Stop to exit Engineering mode and resume use of your treadmill
Calibration Procedure
1. Remove the Safety Key.
2. Press and hold Start and Speed _ buttons and at the same time replace the Safety Key. Continue to hold Start and
Speed _ keys until the window displays “Factory settings”, then press the Enter key.
3. You will now be able to set the display to show Metric or English settings (Miles vs. Kilometers). To do this, press the
incline Up/ Down key to show which you want, then press Enter(The maximum speed value is displayed in the
speed window, and the maximum elevation value is displayed in the incline window.)
4. Grade return – On (This allows the incline to return to zero when Stop button is pressed. For sale in Europe, EU
standards require this to be off )
5. Press Start button to begin calibration. The process is automatic; the speed will start up without warning, so do not
stand on the belt.
Loading ...
Loading ...
Loading ...