Loading ...
Loading ...
Loading ...
Copyright Planika Sp. z o.o. www.planikafires.com IG0031#05 10.10.2019 24
5.2 Installing the control unit (Wall Switch)
The control unit has standard a cable with a length of 8 m (connection for battery supply and for the controlling).
NOTE: The cables may not be extended. Longer cables can pick up environmental signals that can switch the appliance
uncontrolled On or Off.
Determine the location for the control unit (Wall Switch).
Pull the cables through the opening of 5 x 8 cm on the surface on which Wall Switch will be mounted.
Make sure you have ca 12 cm cable length outside of the opening for replacing the batteries.
Connect the switch with the cable and insert the plug into the terminal.
Insert the batteries into the holder and connect the battery holder with the cable.
Screw the front panel on the surface-mounted socket.
WARNING!!!
The Wall Switch should be installed in a casing suitable for the way of installation, e.g. in an installation box
which is installed on surface or concealed, etc., with a waterproof casing class of no less than IP64.
We recommend to place the battery holder in the same casing (located on the Wall Switch rear wall bracket)
or in a separate casing of the same waterproof class, not less than IP64.
Loading ...
Loading ...
Loading ...