Loading ...
Loading ...
Loading ...
Copyright Planika Sp. z o.o. www.planikafires.com IG0031#05 10.10.2019 23
5. OPERATING INSTRUCTIONS
The GaLiO Fire Pit Insert fireplace has a remotely control valve with a built-in ignition for the pilot flame. The flame
height of the main burner may be appropriately regulated by Wall Switch (Touch Panel) or remote control (if
delivered).
Hand-held transmitter and Wall Switch
5.1 Setting up signal code
WARNING! You only need to set up the signal code once. It is not necessary when changing the batteries of the hand-
held transmitter or receiver. The appliance is delivered already configured and ready to work.
In case of lost or damaged of hand-held transmitter the new one has to be programmed and the receiver must first
learn the hand-held transmitter’s signal code before the first use:
Press the “RESET” button on the receiver, and keep this pressed until 2 beeps are heard. Release the “RESET”
button after the second (somewhat longer) beep.
Press, within 20 seconds, the „-“ button (small flame) on the hand-held transmitter, until 2 short beeps are heard.
The signal code has now been set up on the receiver. If, however, a single long beep is heard, this means that setting
the signal code has failed or that the wiring has been connected incorrectly.
Receiver “RESET” button
Loading ...
Loading ...
Loading ...