Loading ...
Loading ...
Loading ...
Broiler Pan and Grid
After broiling, remove the
broiler pan from the oven or
broiler compartment
(depending on your model),
Remove the grid from the
pan Carefully pour out
• grease from the pan into a
proper container, Wash and
rinse the broiler pan and grid
in hot water with a soap-filled or plastic scouring pad°
If food has burned on, sprinkle the grid with detergent
while hot and cover with wet paper towels or a dishcloth.
Soaking the pan will remove burned-on foods.
The broiler pan and grid may be cleaned with a
commercial oven cleaner,
! !
! I
l !
l l
Both the broiler pan and grid can also be cleaned in a
dishwasher
Do not store a soiled broiler pan and grid anywhere
in the range
CAUTION: Do not clean the broiler pan or grid in a
self-cleaning oven.
Oven Shelves
Clean the shelves with an abrasive cleanser or steel
wool, After cleaning, rinse the shelves with clean water
and dry with a clean doth.r
NOTE: Take the shelves out of the oven before you begin
the serf-clean cycle,
Oven Bottom
The oven bottom has a
porcelain enamel finish.
To make cleaning easier,
protect the oven bottom from
excessive spillovers by placing
a cookie sheet on the shelf
below the shelf you are
cooking on, You can use
aluminum foil if you do not
cover the whole shelf, This is
particularly important when baking a fruit pie or other
foods with a high acid content Hot fruit fillings or other
foods that are highly acidic (such as tomatoes or
sauerkraut and sauces with vinegar or lemon juice) may
cause pitting and damage to the porcelain enamel
surface and should be wiped up immediately,
To clean up spillovers, use soap and water, an abrasive
cleaner or soap-filled steel woo! pad, Rinse well to
remove any soap before selFcleaning.
Surface Light and Starter
(on some models)
CAUTION: Do not touch
the bulb with wet hands
or when bulb is hot.
Never wipe the light area
with a wet cloth,
Electrical power must be
shut off if you have to
replace a bulb.
Canopy
Lift up
To replace the bulb:
1. With one hand at each
ht bulb
end of the hinged
canopy, grasp itby the
front edge and flip it up,
2. Remove the fluorescent light bulb. Replace the bulb
with one of the same length and wattage,
3, Lower the canopy.
To replace the starter:
1. Open the canopy and remove the bulb as
explained above.
2. Grasp the starter, turn it counterclockwise about one-
quarter turn and lift out, Replace with one of the same
wattage
3. Replace the bulb and lower the canopy°
32
Loading ...
Loading ...
Loading ...