Loading ...
Loading ...
Loading ...
i i i, i ! , ,
PROBLEM
,, ,, ,,,,,,,,,,,,,,,,,
Surface burner fails to light.
CAUSE
, r ,,, , , , , , ,,,,,
a. power supply not connected.
b. clogged burner port(s).
c. surface control not completely
turned to the LITE position or turned
too quickly from the LITE position.
d. power failure (pilotless ignition).
e,
f.
i, ,, i, , ,, ,i , ,,,,,
Burner flame is uneven, a.
Surface burner flame lifts off port
or is yellow in color.
Surface burner ignitor producing a.
clicking sound.
b.
C.
.................................... ,u , ,, , i
Oven burner falls to light, a.
b.
c.
..... ,, i ,,,
Popping sound heard when
burner extinguishes.
Clock and/or oven light does not
work.
on sealed burner models: Burner
willnot light if the ignitor isdamaged,
soiled, wet or if the port directly be-
low the ignitor is blocked.
burner assembly incorrectly
installed.
,, r, ,,,,,,,,,, , , ,, ,
CORRECTION
a. connect power, check circuit
breaker or fuse box.
b. clean ports with straight pin or small
paper clip. See page 17 for cleaning
instructions.
c. turn control to the LITE position until
the burner ignites, then turn control
to desired flame size.
d. see page 6 to light burner during a
power failure.
e. clean and dry burner head. If broken
or damaged, call a serviceman.
f. see page 7.
clogged burner port(s), a. clean ports with straightpin.
, ,, ,, ,,..... ,, ,,
a. air/gas mixture not proper.
b. no pan in place.
NOTE: Lifting of flame is normal for
sealed burners. Some yellow tipping
with LP gas is normal and acceptable.
control knob is in the LITE position.
NOTE: The life ofthe ignition system
may be shortened ifthe knob is left
in the LITE position.
surface control switch is moist as a
result of cleaning the range.
malfunctioning switch.
power supply not connected.
power failure.
oven incorrectly set.
a. call serviceman to adjust burner.
b. always place pan on grate before
lighting burner.
NOTE: Be sure installer properly
adjusted range at time of installation.
a. be sure ALL surface burner control
knobs are in the OFF position or are
adjusted to the desired flame
setting.
b. allow switch to dry then relight
burner.
c. call serviceman to check.
a. connect power, check circuit
breaker or fuse box.
b. oven will not operate during a power
failure,
c. See page 11.
This is a normal sound that occurs with some types of gas when a hot burner is
turned off. The popping sound isnot a safety hazard and will not damage the
appliance.
, , ,,, , , , , ,, , , ,, ......... ,,,..........
a.power supply not connected.
b. bulb may be loose or burned out.
c. malfunctioning switch, starter or
ballast.
d. malfunctioning clock orloosewiring.
a. connect power supply, check circuit
breaker or fuse box.
b. tighten or replace light bulb.
c. call serviceman to check.
d. call serviceman to check.
(Continued next page)
Loading ...
Loading ...
Loading ...