Loading ...
Loading ...
Loading ...
ww w.drilldoctor.com30
6. Question:
Why is the Chisel Edge on my drill bit at or rounded?
Answer:
• You may have aligned using the white Sharpening lines
instead of the raised Alignment Guides. Make sure to insert
either of the raised ns into the correct alignment slot.
• During the alignment process the Bit Clamp Arms were
gripping the high points of the drill bit. Realign the drill bit
making sure that the Bit Clamp Arms are holding the drill bit
in the narrowest section of the bit.
7. Question:
Why is my split point uneven?
Answer:
You may have used uneven pressure during the splitting process.
To correct an uneven point split, insert the Chuck into the
Splitting Port and split both sides again. Repeat until the split
sides are equal.
8. Question:
Why does the drill bit back up into the Chuck during the
sharpening procedure?
Answer:
• Your Chuck may be dirty. Follow the steps for cleaning the
chuck.
• Your bit may have been loose in the Chuck. Make sure to
tighten adequately before sharpening.
9. Question:
When splitting, why don’t I hear a grinding sound?
Answer:
The Chuck is not seated properly in the Splitting Port. The Chuck’s
Sharpening Guide must line up with the Splitting Guide on the
top of the Split Point Port. Firmly and slowly push the Chuck into
the hole until you hear grinding.
Loading ...
Loading ...
Loading ...