Loading ...
Loading ...
Loading ...
ww w.drilldoctor.com 27
Chuck bit as usual
To prepare your bit for this ne
adjustment, follow all the Steps for
chucking your bit given previously
in this User’s Guide.
Insert Chuck into Alignment
Port
To adjust the Chisel and Relief
Angles, simply align the bit
as usual with the following
adjustment:
To increase Relief—Insert the
Chuck in the Alignment Port closer
to the (+) position. This will make
a more aggressive drill point. Only
adjust 1-slot at a time.
To decrease Chisel and Relief—
Insert the Chuck in the Alignment
Port closer to the (-) position. This
will make a more precise hole. Take
care not to adjust Relief too far as
this will actually cause the drill to
lose all Relief and therefore not drill
a hole.
Each notch in the Alignment Port
is approximately a 10° change in
Chisel Angle.
Tighten Chuck, and sharpen as
usual
Experiment with a few dierent
settings to nd the one that best
suits your drill bit and application.
You may nd it helpful to mark this
setting for future use.
1.
2.
3.
118
Loading ...
Loading ...
Loading ...