Loading ...
Loading ...
Loading ...
11
Electrical connection
WARNING
- Disconnect the appliance from the mains power supply.
- Installation must be carried out by a qualied electrician who is fully aware of current safety and
installation regulations.
- The manufacturer shall not be held liable for injury to persons or animals, or for damage to
property resulting from failure to observe the regulations provided in this chapter.
- The power supply cable must be long enough to allow the hob to be removed from the worktop.
- Ensure that the voltage specied on the appliance rating plate is the same as that of the house
electrical system.
- Do not use extension leads.
Connecting to the terminal board
Use an H05RR-F cable (as indicated in the table below) for the electrical connection.
Conductors Amount x size
220-240 V ~ +
3 x 4 mm²
220-240 V 3 ~ +
5 x 1.5 mm²
380-415 V 3 N ~ +
5 x 1.5 mm²
380-415 V 2N ~ +
4 x 1.5 mm²
CBA
Connect the yellow/green earth wire to the terminal with the symbol .
This wire must be longer than the other wires.
1. Remove the terminal block cover (A), undoing the screw and inserting the cover in the terminal block
hinge (B).
2. Strip approx. 70mm of sheath from the power supply cable.
3. Strip approx. 10mm of sheath from the wires. Insert the power supply cable into the cable clamp and
connect the wires to the terminal board (as indicated in the diagram) next to the terminal board itself.
4. Secure the power cable with the cable clamp.
5. Close the cover (C) and screw it on the terminal block with the removed screw – point (1).
Each time the hob is connected to the mains it carries out an automatic check which lasts several seconds.
If the hob already has a power cable, follow the instructions on the instruction label attached to the cable.
Connect the appliance to the mains electricity supply using a multipole switch disconnector with
minimum contact gap of 3mm.
230 V
230 V
230 V
230 V
230 V
230 V
230 V
230 V
230 V
230 V
230 V
380-415 V 3 N ~
220-240 V ~
220-240 V ~
(AU and UK)
380-415 V 2N ~
220-240 V 3 ~
(Belgium only)
380-415 V 2N ~
(NL only)
Loading ...
Loading ...
Loading ...