Loading ...
Loading ...
Loading ...
,0
,0
,0
,0
iiiiiiiiiiii_i!i!_i_!_i_!_!_i_i_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_:_;i
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii'ii'ii i! ii
Before you call forservice...
Troubleshooting -tips
_ ; (i Possible Causes What To Do
Excessive smoking FLxcessivesoil. * Toud_ tile CLEAR/OFFpad. Open tile windows to rid
the room of smoke. \_'ait m]til the light on the SELF
CLEANpad goes off. _\'ipe up the excess soil and reset
the clean cycle.
Oven door willnotopen Oven too hot. * _Mh>wflw oven to cool below h>cking temperature.
after a clean cycle
Oven not clean after Oven conWols not properly set. * See the Using the self-cleaning oven section.
a clean cycle
vven was heavily soiled. * Clean up heavy spilh)ve_ befi>re starting the clean cycle.
a hmger peri(>d (>f time.
Heavily s(>iled (wens may need to sell_clean again (>r fi)r
Oven door willnot Oven is too hot. * _Mh>w the oven t(> cool beh>w h>cking temperature.
nnlock (on models Do not h>ck the door with the door latch except when
with a doorlatch) usin- the selfXclean feature.
"Door"appears in the Self-cleaxfing cycle has been * Move the latch handle all the way to the fight.
display (on models selected but the latch handle
with a door latch) was not moved all the way
to the right.
Latch handle was moved to the * Move the latch handle to the right only when ,setfiw,
fight but a program other than the sell=cleaning cycle.
self-clemahag was selected.
"F--and a number or On models with a door latch, * The latch may have been moved, even if only slightly,
letter" flash in the display if a function error code appears fl'om the h>cked position. Make sure the latch is moved
during the self-clem_g cycle, to the right as thr as it will _o
check the oven door latch.
You have a fm_ction error code. * Touch the CLEAR/OFFpad. _Mlow the oven to cool for
(>lie h(>t/I: Pt/t the oven back into (>perati(>n.
If the function code repeats. * Disc(mnect all p(>wer t(> the range for 5 Iuinutes
;ind then l'ec(>nnect p(>wel: If the fi/ncti(>n elT(>l"
code repeats, call fin" service.
Oisplaygoes blank A fuse in your home may be * Replace the fl_se or reset the circuit breakeL
blown or the circuit
breaker tripped.
The clock is turned off so that it * See the Using the clock and timer secti(>n.
does not show in the display.
Display flashes Power failure. * Reset the oh>ok.
Unabletoget the Oven control pads were
displayto show "SF" not touched properly.
• The BAKE and BROIL HI/LO pads must be touched at
the same time and held f'm 3 seconds.
4_
Loading ...
Loading ...
Loading ...