Loading ...
Loading ...
Loading ...
,0
iiiiiiiiiig",','i_'i_5:i:i:i:i:i:i:i:i:ig!!i_!!
iiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiii ii, iiiiililililililililiiiiii ii i!ill
,0
,0
-€
q
#_.
m
a__,
Care and cleaning of the range.
Burner Caps and Heads
NOTE: Before removing the burner caps
and heads, remember their size and location.
Replace them in the same location after
cleaning.
Usea sewing needle or twist-tie
to unclog flTesmall hole in the
burner head.
Burner caps
I Jfl off when cool. _Vash bm'ner caps
in hot, soapy water and rinse with clean
water: You max scorn" with a I)lastic scorning
pad to remoxe bm'ned-on food particles.
Burner heads
For proper ignition, make sm'e the
small hole in the section that fits oxer the
electrode is kept open. A ,sewino_needle
or wire twist-tie works well to tmclo_* it
Thesilts in the burnerheads must be keptclean
at aft times for an even, unhamperedflame.
Clogged or dim' burner po_s or electrodes
_ill not allow the bm'ner to operate properly.
A W spill on or aromM an electrode must
be carefifll) cleaned. Take care to not hit an
electrode with an)_hing hard or it could
be damaged.
Y))u should clean the bm'ner caps and
bm'ner heads routinely, especially alter bad
sl)illox e_,.... which could cloo-_the I° )enings,
in the bm'ner heads, i,ifl offwhen cool.
To remoxe bm'ned-on food, soak the
bm'ner heads in a solution of mild liquid
detergent and hot water fi)r 20-30 minutes.
For nlore stubborn stains, use a toothbrush.
After cleaning
Beli)re putting the bm'ner caps and heads
back, shake out excess water and then dry
them thoroughly by setting in a wam_ oven
for 30 minutes.
NOTE:Donotusesteelwoolor scouringpowders
tocleantheburners.
26
Replacement
]_epla('e bm'ner heads over the electrodes
on the cooktop, in the correct locations
according to their size.
Onsome models:
Mediumhead Smallhead
and cap andcap
o4'
,,.° °
Largehead Largehead
and cap andcap
Onsome models:
Mediumhead Smallhead
andcap andcap
Mediumhead Largehead
and cap and cap
Make sm'e the slot in the bm'ner head is
positioned over the electrode,
Replace the matching size caps onto the
heads.
Make sm'e that the heads and caps are
replaced in the correct locations.
NOTE: Onsome models, the burnersare a// the
same sizeand powe_
Loading ...
Loading ...
Loading ...