Loading ...
Loading ...
Loading ...
mnstaaiation mnstructions
[] JNSTALUNG THE ANTbTP
-AWARNING!
• Range_ must be secured with an ai)prmed Anti-Tip
device.
• Unless properly installed, the range could be tipped
b) )ou or a child standing, sitting or leaning on an
oi)eu dooi;
• ,Mter instnlling the M]ti-Tip device, xerit}, that it is in
place by careflflly attempting to tilt tie rouge tin'ward.
• This range has been designed to meet all recognized
industry tip stnndards fin" all nmmal conditions.
• The use of this device does not prechMe tilI) )iu,,,_ of
the range when not proi)erly installed.
• If the Anti-Tip dexice sui_plied with the range does
not fit this ai_plication, use the tmixe_sal Anti-Tip
device _._B2X7909.
A. Mark the wall where the RIGEYF EDGE (ff the m_ge
is to be ]ocated. Be sm'e to a]]o_ for the com_tertop
overhm_g ]f)(m h_tem_d to h_st:d] the mm_ge m_ext to
cabh_ets.
SIo_ed head
screw
Approx. 20
Marked edge of range
B, I x)cate the outside edge of the device 2½" toward
the cem_ter of the m m_ge f}'om the marked edge of
C, [ Jsim_g the device as a template, mark the positio]_ of
the hole for the screw.
D, For wood com_stmctiom drill a pilot hole at am_ m_gle
(ff 20 degrees ti'om the holJzo]_ta]. A mfi] or md
may be I_sed if a dd]] is m_ot a_:fi]ab]e.
Mom_t the Al_ti-Tip device with the screw provided.
For cemem_t or coN_crete co]_stmctin_], yol_ wi]] m_eed
a 1/4" x 1½" lag boil m_d a 1/2" O.D. sleeve m_chox;
which are mint provided. D_J]] the recommemled size
hole %r the hard_are.
[] INSTALLING THE ANTI-TIP
DEVICE (CONT.}
Wallboard
Wood screw
Back of range
In,stall the sleeve m_c]_rn" i_t() the (h:i]]ed hole a_d the]_
i_sta]] the lag bolt throug]] the device. The bolts must be
[)rol)er]y tighte_ed as recommemled tbr the ]_ardware.
E. Slide the ]_mge agai_st the wail am] check for proper
i_stai]atitm 1)_, ,g_s[)i _]g, the {}'trot edge o{ the cooktop
m_d carehd]y attempti_g to tilt the m_ge tbrward.
WHEN ALL HOOKUPS ARE
Make sure a_ controls are left in the off position, Make
sure the flow of combustion and ventilation a_ to the
range is unobstructed,
CONVERTING TO LP GAS (or
converting back to natural gas from LP)
This rm_ge leaves the factory set for use with natural gas.
If you want to convert to LP gas, the conversion must be
performed by a qualified LP gas installer.
The conversion instructions and LP OlJfices C}lll be fimnd
attached to the range next to the pressure regulator:
Kee I) these instructions and the orifices in case wm want
to convert back to natural gas.
43
Loading ...
Loading ...
Loading ...