Loading ...
Loading ...
Loading ...
Add Engine OJJ
1. Place pressure washer on a flat, levelsurface.
2. Cleanarea around oil fill and remove yellow oil fill
cap/dipstick.
3. Using oil funnel (optional), slowly pour contents of
provided oil bottle into oil fill opening.
,
2.
Cleanareaaround fuel fill cap, removecap.
Slowly add regular unleadedfuel (A) to fuel tank (B). Be
careful not to overfill. Allow about 1.5" (4 cm) (C) of tank
space for fuel expansion.
NOTICE: improper treatment of pressure washer can
damage it and shorten its life.
• DO NOTattempt to crank or start the engine before it has been
properly serviced with the recommended oil. This may result in an
engine failure.
4. Replaceoil fill cap/dipstick and fully tighten.
Add Fuel
Fuel mustmeet these requirements:
* Clean,fresh, unleaded gasoline.
* A minimum of 87 octane/87 AKI (91 RON). High altitude
use, see High Altitude.
* Gasoline with up to 10% ethanol (gasohol) or up to 15%
MTBE (methyl tertiary butyl ether) is acceptable.
NOTICE'.Avoid pressure washer damage.
Failureto follow Operator's Manual for fuel
recommendations voids warranty.
* DONOTuseunapprovedgasolinesuch asE85.
* DONOTmixoil in gasoline.
* DONOTmodifyengineto runonalternatefuels.
To protect the fuel system from gum formation, mix in a fuel
stabilizer when adding fuel. SeeStorage. Aii fuel is not the
same. If you experiencestarting or performance problems
after using fuel, switch to a different fuel provider or change
brands. This engine is certified to operate on gasoline. The
emission control system for this engine is EM (Engine
Modifications).
_. WARNING: Fueland its vapors are extremely
flammable and explosive.
Fire or explosion can cause severe burns
or death.
WHENADDINGFUEL
* Turn pressure washer OFFand let it cool at least 2 minutes
before removing fuel cap. Loosen cap slowly to relieve pressure
in tank.
* Fill fuel tank outdoors.
* DO NOT overfill tank. Allow spacefor fuel expansion.
. If fuel spills, wait until it evaporatesbefore starting engine.
. Keepfuel away from sparks, open flames, pilot lights, heat, and
other ignition sources.
. DO NOT light a cigarette or smoke.
3. install fuel cap and wait for any spilled fuel to evaporate.
CAUTION! Alcohol-blended fuels (called gasohol, ethanol or
methanol) can attract moisture, which leadsto separation and
formation of acids during storage. Acidic gas can damage the
fuel system of an enginewhile in storage.
To avoid engine problems, the fuel system should be treated
with a fuel preserveror emptied before storage of 30 days or
longer. If adding a fuel preserver, fill the fuel tank with fresh
fuel. if only partially tiffed, air in the tank will promote fuel
deterioration during storage. If fuel preserver is not used,
drain the fuel tank, start the engine and let it run until the fuel
lines and carburetor are empty. Usefresh fuel next season.
See Storage for additional information.
NEVERuse engine or carburetor cleaner products in the fuel
tank as permanent damage may occur.
HighAltitude
At altitudes over 5,000 feet (1524 meters), a minimum 85
octane / 85 AKi (89 RON)gasoline is acceptable.To remain
emissions compliant, high altitude adjustment is required.
Operationwithout this adjustment will causedecreased
performance, increasedfuel consumption, and increased
emissions. Seea qualified Sears dealer for high altitude
adjustment information. Operation of the engineat altitudes
below 2,500 feet (762 meters) with the high altitude kit is not
recommended.
Loading ...
Loading ...
Loading ...