Loading ...
Loading ...
Loading ...
6. Engagetriggerlockonspraygunandstartengine
followinginstructionsHow to Start YourPressure Washer.
7. Apply detergent to a dry surface, starting at lower
portion of areato be washedand work upward, using
long, even,overlapping strokes.
8. Allow detergent to "soak in" for 3-5 minutes before
washing and rinsing. Reapply as neededto prevent
surface from drying. DO NOTallow detergent to dry on
(prevents streaking).
iMPORTANT:You must flush the detergent siphoning system
after each use by placing the filter into a bucket of clean
water, then run the pressure washer in low pressure for
1-2 minutes.
Pressure Washer Rinsin9
ForRinsing:
1. Slide nozzle backward to high pressure, press trigger
and wait for detergent to clear.
NOTE:You can also stop detergentflow by removing
detergent siphoning tube from container.
2. Keepspray gun a safe distance from areayou plan to
spray.
A WARNING: Kickback from spray gun can cause you to
fall.
• Operate pressure washer from a stable surface.
• Be extremely careful if you must use the pressure washer from
a ladder, scaffolding, or any other similar location.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
3. Apply a high pressure spray to a small area, then check
surface for damage. If no damage is found, it is okay to
continue cleaning.
4. Start at top of area to be rinsed, working down with
same overlapping strokes as you used for washing and
applying detergent.
Cleaning Detergent Siphoning Tube
If you used the detergent siphoning tube, you must flush it
with clean water before stopping the engine.
1. Placedetergent siphoning tube/filter in a bucket full of
clean water.
2. Engagetrigger lock on spray gun.
3. Slide adjustable nozzleforward to low pressure position.
4. Flushfor 1-2 minutes.
5. Shut off engine following instructions How to Stop
Pressure Washerand turn off water supply.
6. ALWAYS point gun in a safe direction and squeezespray
gun trigger to release retained high water pressure.
IMPORTANT:Spray gun traps high water pressure,evenwhen
engineis stopped andwater is disconnected.
_. WARNING:The high pressure stream of water that this
equipment produces can cut through skin and
its underlying tissues, leading to serious injury
and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which can cause
injury.
• Keephighpressurehoseconnectedto pumpand spraygun
whilesystemis pressurized.
• ALWAYSpointspraygun in safedirectionand squeezespray
guntrigger,to releasehighpressure,everytimeyoustop
engine.Engagetriggerlockwhennot in use.
AutomaticCool DownSystem{Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures above
125°F. The system engages to cool the pump by discharging
the warm water onto the ground.
12
Loading ...
Loading ...
Loading ...