Loading ...
Loading ...
Loading ...
2. Unscrew Brass Flare O-Ring
Using the recommended “Needle Nose Plyers” –
unscrew the brass O-Ring which is securing the
Flare Adapter tightly in place, with its nose end
inserted into the open burner hole port.
3. Stow-Away the O-Ring
Important! Be sure to slide the brass O-Ring, if
O-Ring falls below it may be very difficult to pull
it back up as it is a very small area with limited
access under burner compartment.
4. Push the Flare Adapter Out
Push the Flare Adapter out through the port-
hole, while keeping the Brass O-Ring stationary
on the end of Burner.
5. Locate the Flare Adapter in Back
If the Flare Adapter has not been pushed out all
the way, do that now by pulling it out, and
rotate it slightly revealing the Orifice Hole at tip
the Tip of the Flare Adapter Cone.
GAS CONVERSION
–
FLARE
ADAPTER
PAGE 22
Loading ...
Loading ...
Loading ...