Loading ...
Loading ...
Loading ...
DJI Mavic 3
User Manual
57
©
2021 DJI All Rights Reserved.
Sensors: Tap to view the IMU and compass status and start to calibrate if necessary.
Battery: Tap to view the battery information such as battery cell status, serial number and times charged.
Auxiliary LED: Tap to set the auxiliary LED to auto, on, or off. Do not turn on the Auxiliary LED before takeoff.
Aircraft Front Arm LEDs: In auto mode, the aircraft front LEDs will be disabled during recording to ensure the
quality is not affected.
Unlock GEO Zone: Tap to view the information about unlocking GEO zones.
The Find My Drone feature helps to find the location of the aircraft on the ground.
Advanced Safety Settings include the behavior settings of the aircraft when the remote controller signal is
lost, when the propellers can be stopped during flight, and the AirSense switch.
The behavior of the aircraft when the remote controller signal is lost can be set to Return to Home, Descend,
and Hover.
“Emergency Only” indicates that the motors can only be stopped mid-flight in an emergency situation such
as if there is a collision, a motor has stalled, the aircraft is rolling in the air, or the aircraft is out of control
and is ascending or descending very quickly. “Anytime” indicates that the motors can be stopped mid-flight
anytime once user performs a combination stick command (CSC). Stopping the motors in mid-flight will
cause the aircraft to crash.
An alert will appear in DJI Fly when a manned aircraft is detected if AirSense is enabled. Read the disclaimer
in the DJI Fly prompt before using AirSense.
Control
Aircraft Settings: Units Settings.
Gimbal Settings: Tap to set the gimbal mode, advanced settings, gimbal angle, and perform gimbal
calibration.
Remote Controller Settings: Tap to set the function of the customizable button, to calibrate the remote
controller, and to switch stick modes. Make sure to understand the operations of a stick mode before
changing stick mode.
Beginner Flight Tutorial: View the flight tutorial.
Connect to Aircraft: Tap to start linking when the aircraft is not linked to the remote controller.
Camera
Camera Parameter Settings: Displays different settings according to the shooting mode.
General Settings: Tap to view and set histogram, overexposure warning, gridlines, peaking level, white
balance, auto sync HD photos, and cache when recording.
Storage Location: Footage can be stored in the aircraft or on a microSD card. Internal storage and microSD
cards can be formatted. The max video cache capacity settings and camera reset settings can also be
adjusted.
USB Mode: Mavic 3 Cine supports USB mode, enabling users to copy footage when the battery level of
the aircraft is low. Enable USB mode, power on the aircraft, and connect to a computer to use USB mode.
During this time, the internal storage of the aircraft can be accessed but the SD card cannot.
Restart the aircraft and disable USB mode in DJI Fly to exit USB mode. USB mode will be enabled once
again when the aircraft is restarted if it was disabled via DJI Assistant 2.
In USB mode, the aircraft will disconnect from the remote controller, the frame arm light will turn
off, and the fan inside the aircraft will stop.
Transmission
Live Stream Platform, HDMI Output, Frequency, and Channel Mode settings.
Loading ...
Loading ...
Loading ...