Loading ...
Loading ...
Loading ...
BOTH MODELS
INSTALBNG BLADE GUARD
!. From among the loose parts,, Iind the fo_owing hard _
ware:
"2 Truss Head Screws+ I/4.-20 x 5/8
*2 Socket Head Setscrew, I/4-+20 x 7/8
*4 Flat Washer, 17/64 × 9/16 x 3/64
'2 Hex Nuts+ 1/4-20
*4 Lockwashers+ 1/4 E×temal
*2 Wing Nuts, 1/4-20
*2 Square Nuts, t/4o20
1 Spreader Support
1 Spreader Bracket
1 Spreader C_amp
Items markedwith an asterisk (") are shown actuat size,
/
5 -j?
1/4+20 x 7/8 ,__u
SOCKET HD, ., ,
1/4.20 × 5/8 SETSCREW 1/4 iN. EXTERNA..
TRUSS HD SuRb:W LO_KWAStTER
t/420 HEX NUT t/4-20
SQUARE NUT
1/4 20 WING NUT
SPREADER SUPPORT
SPREADER BRACKET
SPREADER C.AMP
17/64 !.D WASHER
2. Make sure blade is all the way up and square with
table.
3. Position Spreader Support on Rod until it is even with
the end of the Rod
WITH TABLE
\
4, Assemble the 7/8 inch _ong setscrews, nuts
lockwashers and washers to the Spreader Support
Bracket and slip the nuts into the s_otinthe Spreader
Support.
5. Finger tighten only the hex nuts.
NOTE: Be sure to put the socket head setscrew through
the slot shaped holes in the Spreader Bracket (see
illustration). This al!ows the Guard and Spreader to be
fined up with the blade. Be sure the socket end of the
setscrew is at the hex nut end of the assembly.
29
Loading ...
Loading ...
Loading ...