Craftsman 113298090 User Manual

Loading ...

assemb|y

4. Lay a straight piece of wood or a framing square on

table to act as a straightedge. If outer edge of

extension is higher of lower than the table surface:

A. Slightly loosen nuts holding bracket to extension

using 7/16 in. wrench.

B. Move end of extension up ordown until outer edge

is even with table surface. Check with Guide Bar.

Tighten nuts.

C. Re-check INNER edge of extension to make sure

it has not moved. Readjust, if necessary.

BOTH MODELS

1. From among loose parts, find:

1 Wire Tie

2. Snap wire tie into 1/4 inch hole in right side of

cabinet. Route motor cord from inside cabinet

through the wire tie. Secure cord in wire tie. Keep

any extra cord on outside of cabinet. Do not push

extra cord inside cabinet.

EXTENSION REMOVED FOR

PICTURE CLARITY

V WIRE TiE

BOTH MODELS

MOUNTING YOUR SAW TO A

WORKBENCH

1/2

To mount the saw on workbench, make sure that there

isan o_ning inthe topof the bench the same size as the

opening inthe bottom of the saw so that the sawdust can

drop through. Recommended working height is33 to 37

inches form the top of the saw table to the floor.

NOTE: All dimensions in inches.

4 HOLES

7/16 DIA.

FRONT OF SAW

Loading ...

Craftsman 113298090 - 10" Table Saw