113298090 User Manual

Loading ...

8. If blade is NOT 45 ° to table, the 45 ° Stop Collar must

be adjusted.

A. Remove Elevation HandwheeL

B. Using a small size screwdriver, reach thru curved

slot in front trim panel and loosen BOTH setscrews

in 45° Stop Collar.

NOTE: If you can't reach the setscrews, turn the Tilt

Handwheel slightly.

C. Rotate the Stop Collar moving it IN or OUT and tilt

blade RIGHT or LEFT, checking with your square,

until blade is 45 ° to table.

D. Tighten the setscrews.

NOTE: If you can't reach the setscrews, turn Tilt

Handwheel slightly.

E. Install Elevation Handwheel.

45 °

STOP COLLAR

TILT SCREW

BACK OF SAW

BLADE ELEVATION

Whenthe Elevation Handwheel isturned CLOCKWISE,

until it stops, the blade must not be more than 2-5/8

inches above the table. If the blade extends more than

2-5/8 inches, the motor could interfere with the under-

side of the table causing misalignment.

With the blade extending 2-5/8 inches above the table,

the Stop Collar and Spacer must be against the Eleva-

tion Screw Pivot Nut. Ifthe blade extends more than 2-

5/8 inches, loosen two screws in Stop Collar, and

readjust it.

;TOP

_LLAR

ELEVATION SCREW

;PACER

ELEVATION SCREW

PIVOT NUT

TILT SCREW

PIVOT NUT

Loading ...

Craftsman 113298090 - 10" Table Saw