Loading ...
Loading ...
Loading ...
assembly
BOTH MODELS
ASSEMBLY OF STEEL LEG SET
Assembly is best done in the location where the saw will
be used.
1. From among the loose parts, find the following hard-
ware:
4 Leveling Feet
*8 Hex Nuts, 3/8-16
*24 Truss Head Screws, 1/4-20 x 1/2
*24 Hex Nuts, 1/4-20
*24 1/4 Externa| Lockwashers
LEVELING FOOT
items marked with an asterisk (*) are shown actual size.
R_v
3/8-16 HEY,NUT
@
114-20 HEX NUT
114-20X1/2 IN.
TRUSS HEAD SCREW
1/4 IN. EXTERNAL
LOCKWASHER
2. Insert three truss head screws through the three
holes near the top of one Leg. Place the Side Stiffener
upto the Leg, as shown, sothat the three screws line
upwiththe holes inthe SideStiffeners marked with an
"X" in the illustration.
3. Place a Iockwasher and hex nut on each screw and
finger tighten the hex nut.
4. Following the same procedure as above, continue to
fasten together the remaining Legs and Stiffeners as
illustrated.
5. Install one 3/8-16 hex nut on each of the Leveling
Feet.
6. Insert a Leveling Foot through the hole inthe bottom
of each Leg so the Leveling Foot pad rests on the
floor.
7. Install another 3/8-16 hex nut on each ofthe Leveling
Feet.
8. Set leg set upright on floor and securely tighten all
nuts.
9. After complete assembly, you may level the saw by
moving the lower nut up or down along the threaded
stud of each Leveling Foot. The upper nut is used to
lock the Leveling Foot into positionwhen the saw is
level.
END
STIFFENER
, , IL i
MODEL 113.226880 ONLY
MOUNTING YOUR SAW TO THE LEG SET
(Model 113.298090 will be mounted later)
1. From among the loose parts, find the following hard-
ware.
*4 Hex Head Screws, 5/16-18 x 1-1/4
*4 Hex Nuts, 5/16-18
*4 Lockwashers, 5/16 In. External
*8 Fiat Washers, 11/32 x 11/16 x 1/16
Items marked with an asterisk (*) are shown actual size.
3/8 IN. HEX NUTS
LEVELING FOOT
5116-18 x 1-1/4
HEX HEAD SCREW
5/16 IN. EXTERNAL
LOCKWASHER
5/16-18 HEX NUT
11132 IN. I.D.
FLAT WASHER
12
Loading ...
Loading ...
Loading ...