Loading ...
Loading ...
Loading ...
2. Placethesawontopofthelegsetsothatthebaseof
thesawlinesupapproximatelyevenwiththeoutlineof
thetopofthelegset.
3. Frombeneaththesawyouwill be abteto locateand
lineupthe fourmountingholesof the saw basewith
the propermountingholesof the saw basewiththe
propermountingholesinthe leg set assembly.
4. Place one flat washer onto each of the four hex head
screws and insert them into each of the mounting
holes. Be sure the screws go through the saw base
holes and the leg set mounting holes.
5. Install a flat washer, Iockwasher, and a hex nut on
each of the four screws and tighten securely.
6. Level the saw to your requirements by adjusting the
leveling feet. Lock leveling feet into position.
7. Securely tighten all leg set screws and nuts.
SAW BASE [
HEX HEAD SCREW ""_._|
FLAT WAS HER --""_c_ 1
END
LOCKWAS"E"17 L
BOTH MODELS
INSTALLING BEVEL POINTER
AND HANDWHEELS
1. From among the loose parts, find the following hard-
ware:
1 Bevel Pointer
* 1 Screw, 8-32 x 3/8
2 Handwheels
2 Screw, Phillips 10-32 x 5/8
*2 Lockwasher, External 3/16
Items marked with an asterisk (*) are shown actual size.
BEVEL POINTER
HANDWHEEL
8-32 x 3/8 SCREW
10-32 x 5/8
PHILLIPS SCREW
©
3/16 IN.
LO CKWASHER
2. Fasten bevel pointer to cradle assembly with 8-32 x
3/8 screw, as shown. Adjustment of the pointer may
be necessary later.
3. Push handwheels onto shafts, as shown, and fasten
each with a 10-32 x 5/8 phillips screw and Iockwasher.
LOCKWiSHE i ER
TILT HANDWHEEL ELEVATION HANDWHEEL
!3
Loading ...
Loading ...
Loading ...