Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE 45
HIGH/LOW BEAM SWITCH
After the low beam headlights are turned on, push
the multifunction lever, located on the left side of
the steering wheel, away from you to switch the
headlights to high beam. Pulling the multifunction
lever back will turn the low beams on.
AUTOMATIC HIGH BEAM HEADLAMP
C
ONTROL — IF EQUIPPED
The Automatic High Beam Headlamp Control
system provides increased forward lighting at night
by automatically controlling the high beams
through the use of a camera mounted on the
windshield. This camera detects vehicle specific
light and automatically switches from high beams
to low beams until the approaching vehicle is out of
view.
NOTE:
The Automatic High Beam Headlamp Control is
enabled through the Uconnect system
Ú page 150.
The multifunction lever must be in the high
beam position and the low beams must be
turned on in order to activate the Automatic
High Beams.
Broken, muddy, or obstructed headlights and
taillights of vehicles in the field of view will
cause headlights to remain on longer (closer to
the vehicle). Also, dirt, film, and other obstruc-
tions on the windshield or camera lens will
cause the system to function improperly.
When set to AUTO, and the low beams are on
and the multifunction lever is in the high beam
position, the system automatically turns the
high beams on or off based on light levels of the
approaching vehicles.
Vehicle speed must be greater than 22 mph
(35 km/h) to activate Automatic High Beams.
Once activated, Automatic High Beams will
remain on until the speed falls below 15 mph
(25 km/h).
FLASH-TO-PASS
You can signal another vehicle with your headlights
by lightly pulling the multifunction lever toward you.
This will cause the high beam headlights to turn on,
and remain on, until the lever is released.
AUTOMATIC HEADLIGHTS — IF EQUIPPED
This system automatically turns the headlights on
or off according to ambient light levels. To turn the
system on, rotate the headlight switch to the AUTO
position for automatic headlight operation. When
the system is on, the headlight time delay feature
is also on. This means the headlights will stay on
for up to 90 seconds (depending on customer
programmable time of 30, 60, or 90 seconds) after
you place the ignition in the OFF position. To turn
the automatic system off, move the headlight
switch out of the AUTO position.
NOTE:
The engine must be running before the headlights
will come on in the automatic mode.
PARKING LIGHTS
Rotate the headlight switch clockwise to the first
detent for parking lights and instrument panel
lights operation. Rotate the headlight switch to the
second detent for headlights, parking lights and
instrument panel lights operation.
NOTE:
For vehicles sold in Canada, the first headlight
switch position is the parking lights and instrument
panel lights position (instead of the OFF position).
Rotate the headlight switch clockwise to the
second detent to turn on headlights, parking lights,
and instrument panel lights operation.
2
22_KL_OM_EN_USC_t.book Page 45
Loading ...
Loading ...
Loading ...