Loading ...
Loading ...
Loading ...
STARTING AND OPERATING 145
16. Turn the ignition to the ON/RUN position, but
do not start the engine.
17. Press and hold the brake pedal.
18. Release the parking brake.
19. Turn the ignition OFF, remove the key fob, and
release the brake pedal.
NOTE:
When towing this vehicle behind another
vehicle, the parking brake must be released.
Steps 1 through 5 are requirements that must
be met before pushing the N (NEUTRAL) button,
and must continue to be met until the shift has
been completed. If any of these requirements
are not met before pushing the N (NEUTRAL)
button or are no longer met during the shift,
then the N (NEUTRAL) indicator light will flash
continuously until all requirements are met or
until the N (NEUTRAL) button is released.
The ignition must be in the ON/RUN position for
a shift to take place and for the position indi-
cator lights to be operable. If the ignition is not
in the ON/RUN position, the shift will not take
place and no position indicator lights will be on
or flashing.
A flashing N (NEUTRAL) position indicator light
indicates that shift requirements have not been
met.
Shifting Out Of N (NEUTRAL)
Use the following procedure to prepare your
vehicle for normal usage.
1. Bring the vehicle to a complete stop, leaving
it connected to the tow vehicle.
2. Apply the parking brake.
3. Turn the ignition to the ON/RUN position, but
do not start the engine.
4. Press and hold the brake pedal.
5. Shift the transmission into NEUTRAL.
6. Using a ballpoint pen or similar object, push
and hold the recessed power transfer unit N
(NEUTRAL) button (located by the selector
switch) for one second.
Neutral Button
7. When the N (NEUTRAL) indicator light turns off,
release the NEUTRAL (N) button.
8. After the N (NEUTRAL) button has been
released, the power transfer unit will shift to
the position indicated by the selector switch.
NOTE:
When shifting the power transfer unit out of N
(NEUTRAL), the engine should remain off to avoid
gear clash.
9. Shift the transmission into PARK.
10. Release the brake pedal.
11. Disconnect vehicle from the tow vehicle.
12. Start the engine.
13. Press and hold the brake pedal.
14. Release the parking brake.
15. Shift the transmission into DRIVE, release the
brake pedal, and check that the vehicle
operates normally.
16. Re-enable the Auto Park Brake feature, if
desired.
4
22_KL_OM_EN_USC_t.book Page 145
Loading ...
Loading ...
Loading ...