Loading ...
Loading ...
Loading ...
SERVICING AND MAINTENANCE 257
2. If equipped with a 2.0L, remove the screws
from the engine air cleaner filter cover and
disconnect the electrical sensor.
Engine Air Cleaner Filter Cover
3. Lift the engine air cleaner filter cover to access
the engine air cleaner filter.
Engine Air Cleaner Filter Assembly
4. Remove the engine air cleaner filter from the
housing assembly.
Engine Air Cleaner Filter Installation
NOTE:
Inspect and clean the housing assembly if dirt or
debris is present before replacing the engine air
cleaner filter.
1. Install the engine air cleaner filter into the
housing assembly with the engine air cleaner
filter inspection surface facing downward.
2. Install the engine air cleaner filter cover onto
the housing assembly locating tabs.
3. Install screws to secure the engine air cleaner
filter cover to the housing assembly and
reconnect the electrical connector (if
equipped).
ACCESSORY DRIVE BELT INSPECTION
When inspecting accessory drive belts, small
cracks that run across ribbed surface of belt from
rib to rib, are considered normal. These are not a
reason to replace belt. However, cracks running
along a rib (not across) are not normal. Any belt
with cracks running along a rib must be replaced.
Also have the belt replaced if it has excessive wear,
frayed cords or severe glazing.
1 — Screws
2 — Electrical Connector
3 — Clean Air Hose Clamp
1 — Engine Air Cleaner Filter
WARNING!
Do not attempt to inspect an accessory drive
belt with the vehicle running.
You can be badly injured working on or around
a motor vehicle. Only do service work for which
you have the knowledge and the proper equip-
ment. If you have any doubt about your ability
to perform a service job, take your vehicle to a
competent mechanic.
8
22_KL_OM_EN_USC_t.book Page 257
Loading ...
Loading ...
Loading ...