Loading ...
Loading ...
Loading ...
MAKING A RiP CUT
See Figure 49.
A
WARNING: Make sure the blade guard assembly is
installed and working properly to avoid serious pos-
sible injury.
[] Set the blade to the correct depth for the workpiece.
[] Position the rip fence the desired distance from the
blade for the cut and securely lock the handle.
[] When ripping a long workpiece, place a support the
same height as the table surface behind the saw for
the cut work.
[]
Make sure the wood is clear of the blade before turning
on the saw.
[] Turn the saw on.
[]
Position the workpiece flat on the table with the edge
flush against the rip fence. Let the blade build up to full
speed before feeding the workpiece into the blade.
[] Once the blade has made contact with the workpiece,
use the hand closest to the rip fence to guide it.
Make sure the edge of the workpiece remains in solid
contact with both the rip fence and the surface of the
table. If ripping a narrow piece, use a push stick and/
or push blocks to move the piece through the cut and
past the blade.
[] When the cut is made, turn the saw off. Wait for the
blade to come to a complete stop before removing the
workpiece.
RiP CUT
RiP
FENCE
BLADE
MAKING A MITER CUT
See Figure 50.
WARNING: Make sure the blade guard assembly
is installed and working properly to avoid possible
serious injury.
[] Remove the rip fence.
[] Set the blade to the correct depth for the workpiece.
[] Set the miter gauge (or miter fence) to the desired
angle and tighten the lock knob.
[] Make sure the wood is clear of the blade before turning
on the saw.
[] Turn the saw on.
[]
Let the blade build up to full speed before moving the
workpiece into the blade.
[] Hold the workpiece firmly with both hands on the miter
gauge (or miter fence) and feed the workpiece into the
blade.
NOTE: The hand closest to the blade should be placed
on the miter gauge lock knob (or the miter fence
adjusting clamp knob) and the hand farthest from the
blade should be placed on the workpiece.
[] When the cut is made, turn the saw off. Wait for the
blade to come to a complete stop before removing the
workpiece.
MITERCUT
BLADE
MITERFEN
ANGLED
HEIGHT/BEVEL
ADJUSTING
HANDWHEEL
Fig. 50
Fig. 49
36
Loading ...
Loading ...
Loading ...