Loading ...
Loading ...
Loading ...
safety instru cti0ns, for scro ml
shaped workpieces; plan
!:_/;;y0ur_workso;iitwiil_-_Ot_pinch: the :blad& A piece Of
:::::_':_iiolding;for examplei rnust :lay flat orbe heid by a
et ittwisL rock or slip whi e
being'cut, i:i.
* ilProperly supp6rt'round material such as dowel
= i:ods or tubing. They have a tendency to rollduring
acuL causing the blade to bite.
o Cut only one worl_iece at atime:
,_ Clear everything except the workpiece and related
support devices off the table before turning the
saw On.
Plan the way you will hold the workpiece
from start to finish.
Do not hand hold pieces so small that your fingers will
go under the blade guard. Use jigs or fixtures to hold
the work and keep your hands away from the blade.
SECURE WORK. Use clamps to hold work when
practical, tt'soften safer than using your hand and
frees both hands to operate the tool.
Avoid awkward operations and hand positions where
a sudden slip could cause fingers or hand to move
into the blade.
DON'T OVERREACH. Keep good footing and
balance.
Keep your face and body toone side of the blade,
out of line with a possibte thrown piece _fthe blade
should break.
WHENEVER SAW IS _RUNNING: ....
WARNING: Don!t:let familiarity (gained=fr0m !
frequent use of your scroll:: Sa_v): :cause:a
!
careless: mistake. A careless :fraction of a
second is enough to Cause::a severe injury.
:.:.:.:_ ._ : _.:
_fore starting your cut, watch the sawwhile it runs, If
it makes an unfamiliar noise or vibrates a lot; stop
immediately. Turn the saw off. Unplug the saw. Do not
restart until finding and correcting the problem,
KEEP CHILDREN AWAY. Keep all visitors a safe
distance from the saw. Make sure bystanders are clear
of the saw and workpiece.
DON'T FORCE TOOL. It will do the job better and
safer at its designed rate. Feed the workpiece into the
saw blade only fast enough to let it cut without
bogging down or binding.
Before freeing any jammed material:
• Turn switch "OFF"
SSIW
When backing up the workpiece, the blade
may bind in the kerf (cut), This is usually
Caused by sawdust clogging up the kerr. If
this happens:
" Turn switch "OFF".
° Remove switch key.
" Unplug the saw.
* Wait for all moving parts to stop.
° With a flat blade screwdriver, turn motor shaft by
hand, by inserting into the slotted end of motor
shaft located at the center of the motor :housing.
Do this while backing up the workpiece.
Before removing loose pieces from the
table, turn saw off and wait for a!! moving
parts to stop.
BEFORE LEAVING THE SAW:
Wait for all moving parts to stop,
MAKE WORKSHOP CHILD-PROOF. Unplug the saw,
Lock the shop or ON!OFF knob. Store the key away
from children and others not qualified to use the tool.
Safety Signal Words
DANGER: means if the safety information is not
followed someone will be seriously injured or killed.
WARNING: means if the safety information is not
foltowed someone could be seriously injured or
killecl.
CAUTION: means if the safety information is not
followed someone might be injured.
• Remove switch key.
• Unplug the saw.
• Wait for all moving parts to stop.
4
Loading ...
Loading ...
Loading ...