Loading ...
Loading ...
Loading ...
Sears recommends the following accessories
Item Sears Number
!Leg Set ....................................................... 9-22244
Blades ............................... See Catalog - For 5" long,
Pin end type blades
Plain End Blade Adapter .............................. 9-22257
Sears may recommend other accessories not listed in
manual. See your nearest Sears Store or Catalog
Department for other accessories.
troubleshooting
WARNING: For your own safety, turn switch "OFF", remove key and
remove plug from power source outlet before troubgeshooting your scroll
saw.
......... PROBLEM__ ......... P,ROBABL,E CAUSE .........
Breaking Blades.
........ , ,,,,,_
,J, ,,,,J,
Motor will not run
Vibration
NOTE: There will
always be some
vibration present
when the saw is
running because
of the reciprocating
motion of the
blade.
Biade Runout- '....
Blade not in-line
with arm motion.
1. Wrong tension
2. Over working blade.
3. Wrong blade application.
4, Twisting blade in wood.
I. Damaged cord"or"plug. ......
REMEDY SUGGESTED
,,LqHtll
1. Adjust blade'ien'sion.
2. Reduce feed rate.
3. Use narrow blades for cutting thin wood,
wide blades for thicker wood.
4. Avoid side pressure on blade.
...... ,................ ,,, , ,,,,
1_ Replace damaged parts before using
saw again.
2. Consult Sears Service. Any attempt to
repair this motor may create a HAZARD
unless repair is done by a qualified
service technician. Repair service is
available at your nearest Sears Store.
1i'See rnountlng instructions in this manual
for proper mounting technique.
2. The heavier your workbench is, the tess
vibration will occur. A plywood
workbench will not be as good a work
surface as the same size solid lumber.
Use common sense in choosing a
mounting surface.
3. Tighten table lock knob.
4. Tighten motor mounting screws.
5. Tighten set screw on eccentric coupling.
2. Damaged motor.
.... 1. lmproper'"mounting of"ihe
saw.
2. Unsuitable mounting
surface.
3. Loose table,
4. Loose motor mounting.
5. Loose eccentric coupling
(See Repair Parts List,
.
Key No, 35).
Blade holders' not aligned.
1'.'"'Loose'n screws hoi'ding bla_d'e]qotdersto
arms. Adjust position of blade holders.
Retighten holders,
.......... , ,,,, ..............
19
Loading ...
Loading ...
Loading ...