Loading ...
IAN SCROLL SAW
i Saw fails due to a defect In
RETURNING THE CRAFTSMAN SCROLL SAW
SERVICE CENTER/DEPARTMENT IN THE
APPLIES ONLY WHILE THIS PRODUCT IS USED IN THE UNITED STATES.
Th_s:Wttrranty gives you specific tegat: rights and you may also have other rights which vary from
state to state.
SEARS, ROEBUCK AND CO., D817 WA HOFFMAN ESTATES, IL 60195
safety instructions for scroll saw
Safety is a combination of common sense, stay!ng
alert and knowing how your scroll saw works.
Read this manual to understand this saw.
BEFORE USING THE SAW
WARNING: To avoid mistakes that could
cause serious permanent Injury, do not pl_ug
the saw in until the following steps are
completed.
Assembly and alignment. (See pages 7 -12)
- Learn the use and function of the speed control
ON-OFF knob, bevel lock knob, blade homders,
blade support, hold down, tension knob, and
blade guard. (See pages 13 -14)
Review and understand all safety instructions and
operating procedures in this manual.:
- Review of the maintenance methods for this saw.
:ii: (See page 18)_Readth e WARNING label below,
found::0n the:baSe of: the saw: : i
::WHEN INSTALLING OR MOVING THE
:SAW
AVOID DANGEROUS ENVIRONMENT. Use the
saw in a dry indoor place, protected from rain.
Keep work area welt lighted.
To avoid Injury from unexpected saw
_ movement:
:'Turn saw off and unplug cord before moving the
i saw.
• Put the saw on a firm level surface where there is
plenty of room for handling and properly
supporting the workpiece
• Support the saw so the table is level and the saw
does not rock.
, Bolt the saw to the work surface if it tends to
slip, walki, or slide during operations like cutting
long heavy boards, ,or when using an auxiliary
table._:_ :iii .. :
i; NEVER IISTAND ON OOL. Serious injury could
occur:if the tooi tips:or you accidentally hit the
2
cutting tool. Do not store anything above or
near the tool where anyone might stand on the
tool to reach them.
To avoid injury or death from electrical shock:
• GROUND THE SAW. This saw has an approved
3 conductor cord and a 3-prong grounding type
plug. Use only 3-wire, grounded outlets rated
120 volts, 15 amperes (amps). The green
conductor in the cord is the grounding wire. To
avoid electrocution, NEVER connect the green
wire to a live terminal.
• Make sure your fingers do not touch the plug's
metal prongs when plugging or unplugging the
saw,
BEFORE EACH USE:
Inspect your saw.
DISCONNECT THE SAW. To avoid injury from
accidental starting, unplug the saw, turn the switch
off and remove the switch key before changing
the setup, removing covers, guards or blade.
Loading ...
Loading ...
Loading ...