Loading ...
Loading ...
Loading ...
RADIANT BROILER
OWNER’S MANUAL 1199797 REV 0 (6/14)
PAGE
10
OF 40
A set of four legs is packed with equipment ordered with legs. (For units ordered with casters, go to Step 2b.)
1. Raise equipment sufciently to allow legs to be attached. For safety, “shore up” and support the equipment with an
adequate blocking arrangement strong enough to support the load.
2. Screw the legs into the leg pad holes, located on bottom at each corner. The legs should be fully screwed into the
leg pads.
3. Lower unit gently onto a level surface. Never drop or allow the unit to fall.
4. Go on to Installation Step 3.
STEP 2A: ATTACH LEGS
Installation of Legs
Figure 5
INSTALLATION
A set of four casters is packed with equipment ordered with casters (instead of legs).
A threaded leg pad is fastened to the base frame at each corner. Each caster has a corresponding mating thread. The
casters can be adjusted to overcome a slightly uneven oor. Casters are provided with a tting for proper lubrication
when required.
1. Raise unit sufciently to allow the casters to be attached. For safety, “shore up” and support the unit with an
adequate blocking arrangement strong enough to support the load.
2. Screw the casters into the holes in the centers of the leg pads. Install the casters that have a locking brake under
the front of the unit.
3. Lower the unit gently onto a level surface. Never drop or allow the unit to fall.
4. Go to Installation Step 3.
STEP 2B: ATTACH CASTERS
NOTICE
For an appliance equipped with casters, (1) the installation shall be made with a connector that complies with the
Standard for Connectors for Movable Gas Appliances, ANSI Z21.69 or Connectors for Moveable Gas Appliances,
CAN/CGA-6.16, and a quick-disconnect device that complies with the Standard for Quick-Disconnect Devices for
Use With Gas Fuel, ANSI Z21.41, or Quick Disconnect Devices for Use with Gas Fuel, CAN1-6.9, (2) adequate
means must be provided to limit the movement of the appliance without depending on the connector and the quick-
disconnect device or its associated piping to limit the appliance movement, and (3) the restraining means should be
attached to a frame member on the back of the unit.
Loading ...
Loading ...
Loading ...