Loading ...
Loading ...
Loading ...
Setting Oven Controls
When Self Clean is finished:
Do not force the door open while self clean is
active. This can damage the automatic door locking system. Use
caution when opening the oven door after self cleaning. The
oven bake and broil elements may appear to have cooled after
they have been turned off. The elements may still be very hot
and burns may occur if these elements are touched before they
have cooled. To avoid possible burns stand to the side of the
oven when opening the oven door to allow hot air or steam to
escape.
Use caution when opening the oven door after
self cleaning. The oven may still be very hot and can cause
burns. To avoid possible burns stand to the side of the oven when
opening the oven door to allow hot air or steam to escape. The
oven bake and broil elements may appear to have cooled after
they have been turned off. The elements may still be hot and
burns may occur if these elements are touched before they have
cooled."
1. CIn message will turn off and Hot will appear in display
window (See Figure 42).
2. Once the oven has cooled down (about 1 hour) and Hot is
no longer displayed, the door Opn message will appear.
When this message turns off the oven door may be opened.
_ Attempting to force the oven door before
open
the door Opn message is gone from the display can ruin the
motor door latch.
3. When the oven interior has completely cooled, wipe away
any residue or powdered ash with a damp cloth or paper
towel.
Important note:
• The kitchen area should be well ventilated. Use an open
window, ventilation fan or exhaust hood during the first self
clean cycle to help eliminate the normal odors associated
the initial clean cycle.
When the clean time finishes the oven door will remain
locked until the oven has cooled sufficiently. In addition to
the clean time that was programmed, allow about 1 hour for
the oven to cool before opening the oven door. The Self
Clean function will not operate when the oven lockout is
active.
Setting Delay Start Self Clean
To start a delay Self Clean with default clean time of 3 hours
and a start time of 9:00 o'clock:
1. Be sure the clock is set with the correct time of day, the oven
is empty and ALL oven racks are removed. Be sure oven
door is completely closed.
2. Press Delay Start.
3. Using numeric keys enter 9 0 0 for time to start.
4. Press to accept.
START
5. Press Self Cleon.
6. Press :START"
If it becomes necessary to stop Self Clean while active:
1. Press sToP;.
2. If Self Clean has heated the oven to a high temperature,
allow enough time for the oven to cool and the door Opn
message to appear ( See Figure 42). When this message
turns off the oven door may be opened.
3. Before restarting Self Clean, be sure to read important
notes below.
Important note:
When Self Clean is active you may check the amount of
clean time remaining by pressing the Self Clean key once.
If your clock is set with the default 12 hr display mode, the
Delay Start for self clean can only be programmed to start
up to 11 hours and 59 minutes after the time showing in the
display (be sure to set the clock to current time before
programming a delay start). To set a Delay Start Self Clean
to begin 12 or more hours (maximum is 23 hours and 59
minutes) after the time of setting, be sure to first set the
control in the 24 Hr display mode.
If Self Clean was active and then interrupted by a power
failure or cancelled before the oven was thoroughly
cleaned, it may be necessary to run another Self Clean
cycle.
• If the oven temperature was high enough when Self Clean
was interrupted the oven control may not allow another Self
Clean cycle to be set for up to 4 hours.
33
Loading ...
Loading ...
Loading ...