Loading ...
Loading ...
Loading ...
1. Read the entire installation manual before beginning the installation. Failure to follow these rules
for safe installation and operation and these instructions could cause a malfunction of the boiler
and result in death, serious bodily injury, and/or property damage.
2. Check all applicable state and local building codes and utility company requirements before
installation. The installation must conform with these requirements in their entirety. In the absence
of these codes, use NFPA Installation Codes and good industry practice.
3. Before servicing the boiler - allow the boiler to cool. Always shut off any electricity and gas
supply connected to the boiler prior to servicing.
4. Inspect gas line for leaks.
5. Be certain gas input rate is correct. Over firing may result in early failure of the boiler sections.
This may cause dangerous operation. Under firing may result in too much air for the pre-mix
burner causing poor or loss of combustion.
6. Never vent the products of combustion from this boiler to an enclosed space. Always vent to the
outdoors. Never vent to another room or to inside a building.
7. Be sure there is adequate outdoor air supply to boiler for complete combustion.
8. Follow a regular service and maintenance schedule for efficient and safe operation.
9. Keep boiler area clean of debris and free of combustible and flammable materials.
10. Proper through the wall or through the roof combustion venting shall be in accordance with the
materials and methods described in this manual. Installation must comply with local codes.
11. This boiler and related hot water heating systems are not do it yourself items. They must be
installed and serviced by qualified professionals.
WARNING
This boiler has been equipped for residential installations. If used for commercial applications, any
additional code requirements must be adhered to for installation. This may require additional controls
including but not limited to a low water cut off, a manual reset high temperature limit, and wiring
and/or piping modifications. The manufacturer is not responsible for any field installation changes
made to a boiler installation which are not described or acknowledged in this manual.
Complete all of the following prior to installing the boiler.
A. CODES
This boiler product is a gas-fired, direct vent, condensing boiler and must be installed in
accordance with all applicable federal, state and local building codes including, but not limited to
the following :
United States - Installation shall conform with National Fuel Gas Code (NFPA-54/ANSI Z223. l-
latest edition)
Canada - Installation shall be in accordance with CAN/CGA-B 149.1 and .2 installation
codes.
Loading ...
Loading ...
Loading ...