Loading ...
Loading ...
Loading ...
assembly
RUBBER GASKET
4. Peel off the protective covering from the rubber gasket
and stick it around the clamp. Make sure it extends a
little beyond each end of the clamp.
The gasket will help to prevent sawdust from leaking
out.
For the most efficient removal of sawdust, attach a
Craftsman Home-n-Shop Vac to the sawdust elbow.
INSTALLING TABLE
Apply a coat of automobile wax to the table.
1. Place the table on the band saw so that the two trunnion
pins and the table lock bolt go through the slot in the
trunnion.
2. Find the 1-1/8" dia. flat washer, a sleeve 11/16" long,
the trunnion lock nut and the table lock handle from
among the loose parts.
3. Hold the head of the table lock bolt inside the band saw
with your left hand and put the 1-1/8" dia. flat washer,
the sleeve,and the handle on the bolt.
4. Screw the nut on the bolt and tighten it with the handle
while the table isin a horizontal position.
TABLE TRUNNION
TABLE LOCK BOLT TABLE LOCK HANDLE
ASSEMBLING STEEL LEGS
1. Assemble the two (2) End Stiffeners and the two (2)
Side Stiffeners usingfour (4) 1/4-20 Truss head screws.
The End Stiffeners are placed on top of each Side
Stiffener as shown. Insert screwsthrough the 9/32 inch
diameter holes and attach Iockwashers and 1/4-20 nuts
and finger tighten nuts.
2. Attach the four (4) legs to the Side and End Stiffeners
using 1/4-20 screws, Iockwashers and nuts as shown.
3. Remove the four (4) Truss head screws which were
assembled in Paragraph No. One. Place the two (2)
Support Channels as shown, in position, align holes in
supports with holes in the Stiffeners, replace Iockwashers
and nuts. Tighten all nuts using 7/16" wrench.
4. Assemble the motor support to steel legs with 1/4-20
screws and nuts. Motor support can be mounted to
either end of stand. Tighten nuts.
5. Install leveling feet as shown. To level Leg Set, loosen
nut on inside of leg and turn nut on outside to raise or
lower feet. Adjust all four levelers, if necessary, and then
tighten nuts on inside of leg.
NOTE: These levelers are not intended for height ad-
justment.
HEX NUT LOCKWASHER
SCREW _ __-- END
STIFFENER
I
SIDE , SIDE STIFFENER
STIFFENER _ I -_--_ J
CHANNEL __
SUPPORT _ I _-_:_t CHANNEL
LOCKWASHE R ___i __, SUPPORT
._J I'!'1_ ', /_ SCREW
SCREW -,'1 I, .l ./
/ / LEGS/I' _ [ }
/ "--_.- U 1\ \.OTOR
l uTsu""°""
I/
I i LOCKWASHER
!Ii,,
LTj'\
LEVELING _ \
.... _ e------_ 1/2-B
rcc. __ HEX NUT
Loading ...
Loading ...
Loading ...