Loading ...
Loading ...
Loading ...
maintenance
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH
"OFF" AND REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE MAINTAINING OR LUBRICATING
YOUR BAND SAW.
TIRES
Pitch and sawdust that accumulate on the tires should be
removed with a stiff brush or scraped off with a piece of
wood. Do not use a sharp knife or any kind of solvent.
When the tires become worn they should be replaced. When
replacing the tires, stretch them around the wheels but do
not glue them on.
GENERAL
Keep your Band Saw/Sander clean.
Remove the sawdust from the inside.
Do not allow pitch to accumulate on the table, the insert,
the guides or the thrust bearings. Clean them with Crafts-
man Gum and Pitch Remover. CAUTION: Do not immerse
tke thrust bearings.
Apply a thin coat of automobile-type wax on the table so
that the wood slides easily while cutting.
MOTOR
Frequently blow out any sawdust from the motor.
If the power cord is worn or cut, or damaged in any way,
have it replaced immediately.
For motor maintenance, follow instructions furnished with
the motor.
LUBRICATION
All of the BALL BEARINGS are packed with greaseatthe
factory. They require no further lubrication.
For motor lubrication, follow instructions furnished with
the motor.
Periodically apply a few drops of oil to the upper wheel
guide rods.
MOTOR OUTLET
ON-OFF SWITCH
C A BLACK
t L rJWHI'ElWH'TE --- I
pOA_E!CLORD _1 GREEI GREEN L
=== GROUND m
Ill II
Wl RING DIAGRAM
WHEEL NOT SHOWN
FOR PICTURE CLARITY
GUIDE RODS
/
RECOMMENDED ACCESSORIES
Item Cat. No.
Floor Base ......................... 9-22213
Miter Gauge ........................ 9-29929
Hold-Down Clamp for Miter Gauge ........ 9-29926
Stop-Rods for Miter Gauge .............. 9-29924
Rip Fence ......................... 9-23433
Blades and Sanding Belts ............ See Catalog
Steel Leg Set ....................... 9-22236
Circle Cutting Attachment .............. 9-24301
Table Extension ..................... 9-24302
Speed Reducer ..................... 9-238961
Power Tool Know How Handbooks
Radial Saw ........................ 9-2917
Table Saw ......................... 9-2918
The above recommended accessories are current and
were available at the time this manual was printed.
22
Loading ...
Loading ...
Loading ...