Loading ...
Loading ...
Loading ...
trouble shooting
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH "OFF" AND REMOVE PLUG FROM POWER
SOURCE OUTLET BEFORE TROUBLE SHOOTING YOUR BAND SAW/SANDER.
TROUBLE REMEDY
Motor will not run.
Blade does not run in the
approximate center of the
upper wheel.
Blade does not run in the
approximate center of the
lower wheel.
Band Saw slows down when
cutting.
Blades breaking.
PROBABLE CAUSE
1. Defective On-Off switch. 1.
Defective switch cord.
Defective switch box receptacle.
2. Motor protector open, 2.
(only if your motor is
equipped with an
overload protector).
Other cause.
1. Not tracking properly.
1. Lower wheel not positioned
correctly on shaft.
1. Belt too loose. 1.
2. Motor pivots in motor base. 2.
3. Cutting too small a radius. 3.
4. Dull blade. 4.
1. Too much tension. 1.
2. Kink in blade caused by cutting 2.
too small a radius or turning the
material too fast when cutting.
Replace defective parts before using
Band Saw/Sander again.
Consult Sears Service. Any attempt to repair
this motor may create a HAZARD unless
repair is done by a qualified service technician.
Repair service is available at your nearest Sears
Store.
1. Adjust tracking, see Assembly Section,
"Installing the Blade."
1. Reposition the wheel, see Assembly
Section, "Installing the Blade."
Adjust belt tension, see Assembly Section,
"Attaching Belt Guards."
Tighten motor base clamp screws. See
Assembly Section, "Motor Installation".
Stop feeding, and back up the material
slightly, until the band saw speeds up.
Replace blade.
Adjust tension. See Getting To Know
Your Band Saw!Sander, "3 Tension
Scales."
Use correct cutting technique. See Basic
Band Saw/Sander Operation Section.
FIGURE 1
I
_.,. 2
10
23
SUPPLIED WITH MODEL 113.243411 ONLY
Key
No, Part No. Description
1
2
3
4
5
7
8
10
11
12
62614
60314
STD541025
STD551225
68060
68059
62615
68061
STD541050
803835
69097
HARDWAREFOR
Leg
t'Screw Truss Hd. 1/4-20 x 5/8
t'Nut Hex 1/4-20
t*Lockwasher, 1/4 External
Channel, Support
Stiffener, Side
Stiffener, End
Support, Motor
t'Nut, Hex Hd. 1/2-13
t Foot, Leveling
*Bag of Loose Parts
MOUNTING TOOL & MOTOR
STD523110
STD551131
STD541231
STD551031
STD532507
t'Screw, Hex Hd. 5/16-18 x 1
t*Lockwasher Ext. 5/!6
t'Nut, Hex Jam 5/16-18
t'Washer 11/32 x 11/16 x 1/t6
t'Bolt, Carriage 5/16-18 x 3/4
* Standard Hardware Item -- May Be Purchased Locally
1-All Parts Contained In Loose Parts Bag
Loading ...
Loading ...
Loading ...