Loading ...
Loading ...
Loading ...
33
Replacing Interior Oven Lights
CAUTION: DISCONNECT THE ELECTRIC POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BEFORE REPLACING BULB.
1. Unscrew glass light cover.
2. Use an oven mitt during bulb removal to protect
your hand in case the bulb breaks.
3. Replace the bulb with a 120 volt, 40 watt appliance
bulb.
4. Replace the light cover.
5. Reconnect power at the main fuse or circuit breaker.
Power Failure
Do not attempt to use during a power failure. Unit will not function.
32
Before starting the Self-Clean cycle:
1. Remove the oven racks, rack supports, and any other items/utensils from
the oven. The high heat generated during the cleaning cycle can discolor,
warp, and damage these items. Do not use foil or liners in the oven. Dur-
ing the Self-Clean cycle foil can burn or melt and damage the oven sur-
face.
2. Wipe off any large spills from the oven bottom and sides. Never use oven
cleaners inside a self-cleaning oven or on raised portions of the door.
3. Some areas of the oven must be cleaned by hand before the cycle begins.
Soils in these areas will be baked on and very difficult to clean if not re-
moved first. Clean the door up to the gasket, the door frame, and up to
2 inches inside the frame with detergent and hot water. Rinse thoroughly
and dry.
To start the Self-Clean cycle:
1. Close the door completely.
2. Turn the oven selector knob clockwise to the self-clean mode.
3. Turn the temperature control knob past the clean setting until the knob
stops. At this time, the clean indicator light will come on. Within 30 sec-
onds the automatic door latch engages and the oven indicator light
comes on. The oven indicator light will remain on until the oven reaches
the self-clean temperature and will then cycle on and off during the self-
clean cycle. When the oven reaches the elevated temperature needed
for self-clean, the door lock indicator light comes on.
4. The door lock indicator light will remain on until the self-clean is com-
pleted or interrupted and the oven temperature drops to a safe temper-
ature. A complete cycle is approximately 3 1/2 hours with an additional
30 minutes needed for the oven to cool down enough for the door latch
to disengage. NOTE: A fan noise will be heard during the self-clean cycle
and will continue to run for the 3-1/2 hour duration of the self-clean cycle.
5. When the cycle is completed, turn both the oven selector and tempera-
ture control knob to the off position. When the oven has completely
cooled, open door and remove any ash from the oven surfaces with a
damp cloth.
To stop the self-clean cycle:
To cancel or interrupt the self-cleaning cycle, turn both the temperature con-
trol knob and the oven function selector knob to "OFF". When the oven
temperature drops to a safe temperature, the automatic door latch will re-
lease and the oven door can be opened. When the oven has completely
cooled, remove any ash from the oven surfaces with a damp sponge or cloth.
Loading ...
Loading ...
Loading ...