Loading ...
Loading ...
Loading ...
En
24
Operating in the single FX mode
1 Press the [TAP] button while pressing the [SHIFT]
button to switch Serato DJ’s DJ-FX mode to the single FX
mode.
The mode switches between the multi FX mode and single FX mode each
time the buttons are operated.
2 Press the [FX1] button or [FX2] button of channel 1 to
select the effect unit to assign.
The number of the deck to which the effect is assigned is highlighted on
the Serato DJ screen.
3 Press one of the effect parameter buttons while
pressing the [SHIFT] button to select the effect type.
The selected effect is displayed on the Serato DJ screen.
4 Press the effect parameter 1 button to turn the effect
on.
The effect switches between on and off each time the button is pressed.
! The effect’s [ON] key is highlighted on the Serato DJ screen.
5 Operate the effect parameter 2 button or the effect
parameter 3 button to switch the effect’s parameter.
! Depending on the type of effect, the button may not light when it is
operated.
6 Operate the effect parameter control(s) to adjust the
effect’s parameter(s).
7 Turn the [FX BEATS] control to adjust the effect time.
! It is also possible to set the BPM value to be used as the basis for the
effect time from the interval at which the [TAP] button is tapped.
For details, see Switching the effect’s tempo mode.
Switching the effect’s tempo mode
With Serato DJ effects, there are two ways to set the effect’s tempo: with
the “auto tempo mode” and the “manual tempo mode”.
! By default, the auto tempo mode is set.
Auto tempo mode
The track’s BPM value is used as the basis for the effect’s tempo.
Manual tempo mode
The BPM value used as the effect’s basis is calculated from the interval
at which the [TAP] button is tapped.
Switching to the manual tempo mode
While in the auto tempo mode, press the [TAP] button
three times.
! When the [TAP] button is pressed for over 1 second while in the
manual-tempo mode, the mode switches to the auto tempo mode.
Using the SOUND COLOR FX function
These are effects that change in association with the [COLOR] control.
1 Press one of the [SOUND COLOR FX] buttons.
This selects the type of effect.
The button that was pressed flashes.
! Even when one of the [SOUND COLOR FX] buttons is selected, if a
different [SOUND COLOR FX] button is pressed, the newly pressed
button is selected.
! For the types of effects, see Types of SOUND COLOR FX effects on
page 25 .
! The same effect is set for all channels.
2 Turn the [COLOR] control.
The effect is applied to the channel(s) for which the control(s) was (were)
turned.
Canceling the SOUND COLOR FX effect
Press the flashing [SOUND COLOR FX] button.
The effect is canceled.
Using the oscillator function
You can add a noise-based built-in audio source.
1 Use the [OSC ASSIGN] switch to select the channel to
which you want to apply oscillator sound.
! [CH3]: Applies oscillator sound on channel 3.
! [CH4]: Applies oscillator sound on channel 4.
! [MASTER]: Adds oscillator sound to the master output.
Loading ...
Loading ...
Loading ...