Loading ...
Loading ...
Loading ...
...............................ASSEMBLY
HOW TO INSTALL THE SEAT
Usethe fasteners shown belowto instal!theseal The fastenersare
shown at full size.,
2,,
iiiiii!ltti
'"(Ai ..... (S)
lx45 18x16
(D)
2x53 15x88
Set the seat bracket on the seat support (Figure 5). Pull the
wire harness between the seat hinge and the seat brackeL
Fasten the seat bracket to the seat support with the fasten-
ers_ Do not tighten the fasteners.
Seat Hinge
SeatBracket
C
Figure 5
3. Carefully remove the protectivesleeve and the plastic bag from
the seat, Do not damage the wire attached to the bottom of the
seat,.
4_ Align the holes in the seat hinge to the holes in the seat
(Figure 6).,Fasten theseat tothe seat hinge withthefasteners
as shown. Tighten the fasteners
5_
Check the operating position of the seat. if the seat needs to
be adjusted, slide the seat bracket forward or backward along
the seat adjusting holes as shown.Tokeep the seat straight,
tightenthe rear nut and then tightenthe twofront nuts.
6,, Fasten the connector to the wire harness. Make sure thetab
on the connector locksinto the wire harness.
WARNING: For correct and safe operation of the unit,
fasten the connector to the wire harness, if the
connector is not attached, the engine will stop when
the attachment clutch is engaged.
CHECK THE LEVEL OF THE MOWER HOUSING
NOTE: After the unit is fully assembled, read the Operation
section,
The level ofcut was setat the factory,.Tocheckthe levelofcut, mow
a short distance and look at the area that was cut. If the mower
housing does not cut level, see the instructions on "How To Level
The Mower Housing" in the Service And Adjustment section of this
instructionbook.
F-98668 10
Loading ...
Loading ...
Loading ...