Loading ...
Loading ...
Loading ...
EN
10
5 - Gas Cooktop Operation
The Burner Flames
Turn each burner on. Flames should be blue in color with no
trace of yellow. The burner flames should not flutter or blow
away from the burner. The inner cone of the flame should be
between1/2”and3/4”long.
NOTE:•Foreignmaterialinthegasline,especiallyinnew
construction, may cause an orange flame during
initial operation. The orange color will disappear
with further use. Small yellow tips on the ends of
the flames are normal when using LP gas.
•Iftheflameis not even around the edge ofthe
burner, wait for the cooktop to cool and check to
make sure the burner is assembled properly
Super Sealed Surface Burners
IMPORTANT
Do not obstruct the flow of combustion and
ventilation air around the burner grate edges.
Burner cap and gas spreader
Always keep the burner cap and gas spreader in place when
using a surface burner. A clean burner cap and spreader
will help prevent poor ignition and uneven flames. Always
clean the parts after a spillover and routinely remove and
cleanaccordingtothe“GeneralCleaning”section.
Burner base and injector
Gas must flow freely throughout the injector orifice to light
properly. Keep this area free of soil and do not allow spills,
food, cleaning agents or any other material to enter the
injector orifice opening.
Protect it during cleaning.
BURNER FLAME
Be sure when lighting the burner:
• Gas spreader is seated correctly and pin is properly
aligned with burner base slot.
• Cap is seated correctly and pin is properly aligned with
gas spreader slot.
Burner ports
Check burner flames occasionally. A good flame is blue in
color, not yellow.
Keep this area free of soil and do not allow spills, food,
cleaning agents or any other material to enter the burner
ports.
To Clean gas burner:
IMPORTANT
Before cleaning, make sure all controls are off
and the cooktop is cool.
1. Remove the burner cap from the burner base and clean
according to cleaning section.
2. Remove the burner spreader.
Clean the gas tube opening and burner port according to
cleaning section.
3. Clean the burner base with a damp cloth (keep the gas
injector area free of cleaning agents and any other
material from entering the injector orifice).
4. Replace the burner spreader and cap, making sure the
alignment pins are properly aligned with the slots.
5. Turn on the burner.
If the burner does not light, check cap and spreader
alignment. If the burner still does not light, do not service
the gas burner yourself.
Contact a trained repair specialist.
EXPLODED VIEW OF BURNER
Loading ...
Loading ...
Loading ...