Loading ...
Loading ...
Loading ...
RABBETING
RABBETINGis known as cutting out a section of the
corner of a piece of material, across an end or along
an edge.
To make a RABBET requires cuts which do not go
all the way through the material. Therefore the blade
guard must be removed.
1. Remove blade guard.
For rabbeting along an edge (long way of
workpiece) as shown, add facing to rip fence (see
6, RIP FENCE, p. 25) approximately as high as the
workpiece is wide. Adjust rip fence and blade to
required dimensions; then make first cut with
board flat on table as any rip (type) cut; make
second cut with workpiece on edge. Follow all
precautions, safety instructions, and operational
instructions as for ripping, or rip type operations,
including feather boards and push stick, etc.
3. For rabbeting across an end, for workpiece 10-
1/2" and narrower make the rabbet cut with the
board flat on the table using the miter gauge fitted
with a facing (per "7, MITER GAUGE p. 25) DO
NOT use the rip fence.
4. INSTALL BLADE GUARD IMMEDIATELY
UPON COMPLETION OF RABBETING
OPERATION.
Rabbet cuts can also be made using the dado head
or molding head.
RABBET
FIRST CUT
DADOING
Instructions for operating the Dado Head are
contained in a booklet furnished with the Dado
Head.
The Recommended Dado Head is listed under
Recommended Accessories in this manual.
The arbor on the saw, is only long enough so that
the widest cut that can be made is 13/16" wide.
It is not necessary to install the outside loose collar
before screwing on the arbor nut. Make sure the
arbor nut is tight. "
ALWAYS USE DADO INSERT LISTED UNDER
RECOMMENDED ACCESSORIES.
When using the dado head it will be necessary to
remove the Blade Guard and Spreader. USE
CAUTION. USE FEATHERBOARDS AND PUSH
STICKS AS REQUIRED.
ALWAYS REPLACE THE BLADE, GUARD AND
SPREADER WHEN YOU ARE FINISHED
DADOING.
SAW TABLE
\
DADO INSERT
/
HEAD
MOLDING CUTTING
Instructions for operating the Molding Head are
contained in a booklet furnished with the Molding
Head.
The recommended molding head is listed under
"Recommended Accessories" in this manual.
Always use Molding Insert Listed Under
"Recommended Accessories."
When using the molding head it will be necessary to
remove the Blade Guard and Spreader. USE
CAUTION. USE FEATHERBOARDS AND PUSH
STICKS, etc. AS REQUIRED.
ALWAYS REPLACE THE BLADE GUARD AND
SPREADER WHEN YOU ARE FINISHED
MOLDING.
39
Loading ...
Loading ...
Loading ...