Loading ...
Loading ...
Loading ...
Lay REAR FENCE GUIDE BAR on table to.act.,_S a
straightedge. If outer edge of extension is hig'h'er or
lower than table surface:
A. Slightly loosen nut holding the corner support
bracket to extension using 7/16 in. wrench.
B. Move end of extension up or down until outer
eoge is even with table surface.., check with
GUIDE BAR... tighten nuts.
C. Recheck INNER edge of extension to make sure
it has not moved ... readjust, if necessary.
INSTALLING RIP FENCE GUIDE BARS
1. From among the loose parts find the following
hardware:
2 Hex Head Screws, 5/16-18 x 1-3/4 in. long
2 Hex Head Screws, 5/16-18 x 1 in. long
4 External Lockwashers, 5/16 m.
(approx. dia. of hole 5/16 in.)
4 Hex Nuts, 5/16-18
(approx. dia. of hole 5/16 in.)
2 Spacers, 3/4 in. dia. x 1/2 in. long
2 Self-threading nuts
1 Fence Guide Bar Rod
2. Lay guide bars on saw table.
NOTE: The various holes in the bar allow them
to be positioned on this saw and also makes
them adaptable to other models.
3. Insert a 1-3/4 inch long screw through the
THIRD hole from LEFT IN THE FRONT
BAR... Insert another 1-3/4 inch long screw
through the SEVENTH hole in bar.
4. Place spacers on screws.
REAR GUIDE BAR
7TH HOLE
3RD HOLE
\
\
\ LEFT SIDE
OF FRONT
GUIDE BAR
INSERT BOLTS
5, Turn front bar end for end and insert bolts
through holes in middle and on right side of
front of saw table as illustrated . . . install
Iockwashers and nuts. DON'T SCREW NUTS
ON ALL THE WAY, just get them started on the
screws.
6. Remove the 3 screws from rear of right table
extension.
7. Insert 1 in. long screws in SECOND and
FOURTH holes of rear bar and attach to table
the same way as front bar.
8. Insert ends of FENCE GUIDE BAR ROD
through holes in bars as illustrated.
NOTE: The ends of the ROD are not
threaded.., the SELF THREADING NUTS will
cut threads on the rod as they are screwed on.
FENCE GUIDE
BAR ROD
4TH HOLE
2ND HOLE
12
Loading ...
Loading ...
Loading ...