Loading ...
Loading ...
Loading ...
9. Hold rod with one hand and with a 1/2 in. wrench
or pliers start screwing on ONEof the nuts only
A TURN OR TWO ... screw on other nut the
same way.
10. Using TWO 1/2 in. wrenches or pliers tighten
both of the nuts.
11. Slide the bars so that screws are in the MIDDLE
of the slotted holes.
12. Position rip fence over miter gauge groove,
holding up the rear end while engaging front
end with bar.,, lower fence onto table.
13. Plug saw into power outlet.
14. Insert yellow key into MASTER switch and turn
on.
15. Press _ key. A "E" " will be displayed.
16, Press and hold jog key L__ to
raise sawblade
about 3 inches above table surface. Release key,
NOTE; Display will not show elevation or angle
until saw is "calibrated". This is described after
assembly is complete.
17. Press _ key,
@
YELLOW
KEY
OTOR
TO LOCK
REMOVE
YELLOW
KEY
MINUS
JOG
KEYS
ELEVATION BEVEL
KEY KEY
18. Place a square against the blade. Make sure
square is not touching the TIP of one of the saw
TEETH.
19. Press and release _ and _ keys.
to bring blade square with table.
20. Turn switch off and remove yellow key.
21. Remove plug from power source.
MAKE SURE SQUARE
IS NOT TOUCHING
TIP OF TOOTH
13
Loading ...
Loading ...
Loading ...