Loading ...
Loading ...
Loading ...
MOUNTING THE MOTOR:
1. From among the Ioo,se parts,"find the following
hardware:
2 Hex Head Screws 5/16-18 x 5/8 in. long
4 Carriage Bolts, 5/16-18 x 3/4 in. long
4 Hex Nuts, 5/16-18
(approx. dia. of hole 5/16 in.)
4 Lockwashers, 5/16 in_ External Type
(approx. dia. of hole 5/16 in.)
2. Place motor on MOTOR BASE .... insert bolts
through holes in base.., then through the
motor. Install Iockwashers, and nuts.
3. Position motor so that edge of MOTOR FOOT
and MOTOR BASE are even ... slide motor all
the way to the RIGHT... tighten the four nuts.
LOCKWASHER THESE TWO CARRIAGE BOLT
6/16 IN. EDGES EVEN 5/16-18 X 3/4 IN.
5/16-18
__ _ MOTOR BASE
MOT% sOUNT'NG
4. Screw the two 5/16-18 x 5/8 in. motor base
clamp screws part Way into tapped holes in
cradle.
5. Lift motor and insert the TWO PINS on motor
base into HOLES in cradle.., push motor in as
far as it will go.
6. Tighten the two motor base clamp screws.
CLAMP SCREWS
5/16-18 X 5/8 IN. "_"
HEX. HD. SCREWS
7. Loosen the two MOTOR CLAMP SCREWS on
each end of motor. Rotate the motor so that the
CAPACITOR COVER is on top.., tightenthe
screws. The ventilation holes are now facing
downward which will help prevent sawdust from
entering motor.
CAPACITOR
COVER
\
VENTILATION
HOLES
MOTOR
CLAMP SCREWS
(BOTH ENDS)
10
Loading ...
Loading ...
Loading ...