Loading ...
Loading ...
Loading ...
nstallmg Your Refrigerator
How to Connect the Water $upp|y
WARNING I
To reduce the risk of injury or death_ follow basic precautians_ including the fallowing:
Read all instructionsbefore installing device.
DO NOT attempt installation if instructions are not understood or if they are beyond personal skill level.
Obsewe all local codes and ordinances.
DO NOT service device unless specifically recommended in owner's manual or published user-repair
instructions.
Disconnect power to unit prior to installing device.
CAUTION I
To avoid property damage er possible injury_ follow basic precautions_ including the
following:
Consult a plumber to connect copper tubing to household plumbing to assure compliance with local codes and
ordinances.
Confirm water pressure to water valve is between 20 and 100 pounds per square inch. Ifwater filter is installed,
water pressure to water valve must be a minimum of 35 pounds per square inch.
DO NOT use a self-piercing, or a/_,, saddle valve! Both reduce water flow, become clogged with time, and
may cause leaks if repair is attempted.
Tighten nuts by hand to prevent cross threading. Finish tightening nuts with pliers and wrenches. Do not
overtighten.
Wait 24 hours before placing unit into final position to check and correct any water leaks.
M_ltedals ZVceded
* V4" outer diameter
flexible copper tubing
NOTE: Add 8: lo tubing length needed to reach water
supply for creation of service loop.
• Shut-off valve (requires a _14" hole
to be drilled into water supply
before valve attachment)
• Adjustable wrench
• _¼"hex nut driver
SIMe brass out over sic'eve and
screw aut into in[et porto
iMPORTANT; DO RIOT Overtighten.
Cross threading may occur,
F
PuN on tubin# to confinz_
coanection is secure.
Coaaect tubing* to frame with
water tubing* clamp (F) aad turn
on water supp_v. Check fat
leaks and correct_ # present.
_ U Monitor water connection for 24 bogaw. -_
Co!.rec,:ea s,i:5ce:s r 2
Loading ...
Loading ...
Loading ...