Loading ...
Loading ...
Loading ...
and Care
How to Remove and Replace Light Bulbs
I WARNING I
To avoid eHectricaHshock which can cause severe personai injury or death,
disconnect power to refrigerator before repiacing Hightbuib. After repiacing Hight
bulb, connect power.
I CAUTION I
To avoid personai injury or property damage, observe the following:
* Ailow Hightbuib to cooi
* Wear gioves when repiacing Hightbuib
f" Fresh food section o o "_
1. Remove screw from light shield. Retain for _ _ _ /
replacement . _ / /
1 Siide shieHd toward back of compartment to .'---__O _ |
release from light assembly _1_ _ /
2 Remove light bulbs !1" |
3. Replace with appliance bulbs no greater than _ |
40 watts. _- _ i
4. Replace light bulb cover by inserting E_ |
tabs on light shield into liner hobs on _ _ _ |
j
each side of light assembly. Slide shield -__ |
toward front of unit until it locks into place .'---._O _ |
DO NOT force shield beyond locking point _1_ _ /
Doing so may damage light shield II /
5_,eplacescrew removed in step 1 _
I Freezer section a
1. Pinch rear tabs (A) on light cover and pull straight
out.
2_ Remove light bulb. _'_/_11
3. Replace bulb with appliance bulb no greater ] [_ )_/ Jl
than 40 watts.
4. Insert top tabs (B) of light cover into refrigerator _
liner and snap back portion over light assembly
B .,
How to Get the
Most Out of
Your Energy
Dollar
* When placing refrigerator into final
position, allow for i" clearance
around the mp and sides of unit m
supply ample ventilation for
optimtm_ energy efticiency.
° Avoid overcrowding leffigemtor
shelves. This reduces effectivity of
air circulation around _bod and
causes retiigerator to run longer.
° Avoid adding too much warm £_od
to unit at one time. This overloads
compartments and slows rate of
cooling.
° Do not use aluminum £_il, wax
paper, or paper toweling as shelf
liners. This decreases air flow and
causes unit to run less e_iciently.
* A _}eezer that is 2,/s_:ullruns most
etl]ciently.
* Locate re*i'igerator in coolest part of
room. Avoid areas of direct sunlight,
or near heating ducts, registers, or
other heat producing appliances. If
this is not possible, isolate exterior
by using a section of cabinet or an
added layer of insulation.
• Refer to owner's manual section on
ternperamre controls for
recommended control settings
° Clean door gaskets every three
months according to Owner's
Mannal cleaning instructions. This
will assure that door seals properly
and unit runs et_]ciently.
* Take time to organize items in
refrigerator to reduce time that door
is open.
* Be sure your doors are closing
securely by leveling unit as
instructed in your Owner's Manual
* Clean condenser coils of as
indicated in the owner's manual
every 3 months. This will increase
energ_ e[_ciency and cooling
per_brmance.
i5
Loading ...
Loading ...
Loading ...