315216260 Owner's Manual

Loading ...

SQUARING TABLE TO THE BLADE

See Figures 9 and 10.

• Loosen the hold down foot lock knoband move

hold down rod all the way up. Tighten knob.

• Loosen the table lock knoband movethe table

until itis approximately perpendicular, or st right

angle to the blade.

• Place a small square on the table next to the

blade tocheck ifthe table is90 degrees tothe

blade. If adjustment isneeded, raise or lower the

table until table is approximately 90 degrees to

the blade and securely tighten the table lock

knob.

• Loosen the screw holdingthe scale indicator,

move indicatorto the 0 degree mark and se-

curely tighten screw. Remember, the bevel scale

is a convenient guide but shouldnot be relied

upon for precision. Make practice cutson scrap

material to determine ifyour angle settings are

correct.

• Adjust the hold downfoot to desired positionand

securely tightenthe hold down foot knob.

HOLDDOWNROD

HOLDDOWNFOOT

LOCKKNOB

HOLDDOWN

F00T/

. SAWBLADE

TABLELOCK

KNOB

Fig. 9

SETTING THE TABLE FOR HORIZONTAL

OR BEVEL CUTTING

See Figures 10, 11 and 12.

A bevel scale is providedunder the work table as a

convenient guide for settingthe approximate table

angle for bevel cutting.When greater precision is

required, make practice cuts on scrap material and

adjustthe table as necessary for your requirements.

An adjustable zero degree stop isprovided to quickly

return the table to the zero degree setting.

• Loosen the table lock knoband pushdown on

the rightside ofthe table. Ifthe table stopsat O',

the zero degree stop isproperly set. Ifthe table

stops somewhere other than zero, then adjust

the zero degree stop.

ZERODEGREE II I

"__ SCALE

TABLELOCK SCREW

KNOB Fig. 10

• To access the zero degree stop, loosen the table

lookknob, and tilt the table with the dghtside all

the way down. Just under the front ofthe saw

table is the zero degree stop. See Figure 11.

Loosen the hex nut and rotate the hex boltto

raise or lowerthe boltas needed to adjust the

zero degree stop. Be sure to check to see that

the table is square to the blade.

Now, by returningthe table to the zero position, the

zero degree stop provides a quick reference tothe

preset position.

Loading ...

Owner's Manual - Page 13