Loading ...
Loading ...
Loading ...
34
SERVICE AND MAINTENANCE
7. Re-install the deck making sure the belt remains routed
around the pulleys as instructed.
8. On manual PTO units, re-install the engine pulley keeper rod
and the PTO cable.
9. Pull the right side of the belt and place the narrow “V” side of
the belt into the PTO pulley. See Figure 55.
Figure 55
10. While holding the belt and pulley together, rotate the pulley
to the left. Continue holding and rotating the pulley and belt
until the belt is fully rolled into the PTO pulley.
Removing the Front Bumper (If equipped)
WARNING
Disengage the PTO, engage the brake lock, and stop
the tractor engine before performing any maintenance
procedures. Place the tractor on a firm and level surface
before beginning installation or removal procedures.
The exhaust system and surrounding areas are HOT. To avoid
personal injury, allow the tractor to cool before beginning
any brush guard installation or removal procedures.
1. Remove the four hex screws (a) securing the front bumper in
place. See Figure 56.
2. The front bumper (b) may now be removed.
(a) (a)
(b)
Figure 56
Removing the Brush Guard (If equipped)
WARNING
The exhaust system and surrounding areas are HOT. To avoid
personal injury, allow the tractor to cool before beginning
any brush guard installation or removal procedures.
1. Remove two cotter pins, and then pull the pins. See Figure 57.
1
2
Figure 57
2. The brush guard assembly may now be removed. See
Figure 58.
Figure 58
NOTE: The FastAttach™ brackets may be left in place for use with
other FastAttach™ attachments. Contact your authorized service
dealer for a complete list of products and availability.
Changing the Transmission Drive Belt
Several components must be removed and special tools used in
order to change the tractor’s transmission drive belt. Contact
your authorized service dealer to have the transmission drive
belt replaced.
Loading ...
Loading ...
Loading ...