Loading ...
Loading ...
Loading ...
11
ASSEMBLY
The hardware for attaching the front bumper is shipped installed
into the bumper.
1. Remove the four hex screws (a) from the bumper (b). See
Figure 15.
2. Position the bumper brackets to the inside of the tractor’s
frame and secure it in place with the four hex screws (a). See
Figure 15.
(a) (a)
(b)
Figure 15
INSTALLING THE FASTATTACH™ BRUSH GUARD
(IF EQUIPPED)
1. Align the brush guard assembly with the FastAttach™
brackets and push assembly together. See Figure 16.
Figure 16
2. Install the pins on the right and left side of brush guard and
then secure with two cotter pins found in the hardware pack.
See Figure 17.
NOTE: Pulling up lightly on the brush guard may make
installation of the pins easier.
1
2
Figure 17
LOWER DECK DISCHARGE CHUTE DEFLECTOR
WARNING
Never operate the mower deck without the chute deflector
installed and in the down position.
For 46” deck models:
1. Remove the keys attached with a zip tie to the chute bracket.
2. Remove the flange lock nut and hex screw from the deck.
3. Place the chute deflector on the deck, be sure to insert the
tabs on the chute deflector into the holes on the deck. See
Figure 18.
4. Slide the chute deflector toward the rear of the tractor until
the bolt hole in the chute deflector aligns with the hole in the
deck. See Figure 18.
3
4
5
5
4
Figure 18
5. Secure the chute deflector in place with the flange lock nut
and hex screw removed in Step 2. Tighten to 102-124 in-lbs
(11.5-14 N-m). See Figure 18. Skip ahead to Setting the
Deck Wheels.
Loading ...
Loading ...
Loading ...